4.4 Article

Simultaneous Measurements of Temperature and CO Concentration in Stagnation Stabilized Flames

Related references

Note: Only part of the references are listed.
Article Engineering, Mechanical

Temperature and species measurement in a quenching boundary layer on a flat-flame burner

Takayuki Fuyuto et al.

EXPERIMENTS IN FLUIDS (2010)

Article Engineering, Mechanical

Heat flux measurements in stagnation point methane/air flames with thermographic phosphors

Mohamed Salem et al.

EXPERIMENTS IN FLUIDS (2010)

Article Optics

Two-dimensional thermographic phosphor thermometry using a CMOS high speed camera system

T. Kissel et al.

APPLIED PHYSICS B-LASERS AND OPTICS (2009)

Article Engineering, Multidisciplinary

A quasi-adiabatic laminar flat flame burner for high temperature calibration

Mark Aurel Gregor et al.

MEASUREMENT SCIENCE AND TECHNOLOGY (2009)

Article Engineering, Multidisciplinary

Absorption sensor for CO in combustion gases using 2.3 μm tunable diode lasers

X. Chao et al.

MEASUREMENT SCIENCE AND TECHNOLOGY (2009)

Article Optics

An algorithm for the characterisation of multi-exponential decay curves

J. Bruebach et al.

OPTICS AND LASERS IN ENGINEERING (2009)

Article Thermodynamics

Simultaneous phosphor and CARS thermometry at the wall-gas interface within a combustor

J. Bruebach et al.

PROCEEDINGS OF THE COMBUSTION INSTITUTE (2009)

Article Engineering, Mechanical

Combined phosphor and CARS thermometry at the wall-gas interface of impinging flame and jet systems

J. Bruebach et al.

EXPERIMENTS IN FLUIDS (2008)

Article Engineering, Multidisciplinary

Gas compositional and pressure effects on thermographic phosphor thermometry

J. Bruebach et al.

MEASUREMENT SCIENCE AND TECHNOLOGY (2007)

Article Optics

Comparison of two-photon excitation schemes for CO detection in flames

S Linow et al.

APPLIED PHYSICS B-LASERS AND OPTICS (2000)