Journal
ENVIRONMENTAL SCIENCE AND POLLUTION RESEARCH
Volume 22, Issue 3, Pages 2311-2327Publisher
SPRINGER HEIDELBERG
DOI: 10.1007/s11356-014-3511-6
Keywords
Oil-in-water emulsion; Microfiltration; Gas; sparging; Optimization; RSM
Categories
Ask authors/readers for more resources
Response surface methodology (RSM) and central composite design (CCD) were used to develop models for optimization and modeling of a gas sparging assisted microfiltration of oil-in-water (o/w) emulsion. The effect of gas flow rate (Q (G) ), oil concentration (C (oil) ), transmembrane pressure (TMP), and liquid flow rate (Q (L) ) on the permeate flux and oil rejection were studied by RSM. Two sets of experiments were designed to investigate the effects of different gas-liquid two-phase flow regimes; low and high gas flow rates. Two separate RSM models were developed for each experimental set. The oil concentration and TMP were found to be the most significant factors influencing both permeate flux and rejection. Also, the interaction between these parameters was the most significant one. At low Q (G) , the more the gas flow rate, the higher the permeate flux; however, in the high gas flow rate region, higher Q (G) did not necessarily improve the permeate flux. In the case of rejection, gas and liquid flow rates were found to be insignificant. The optimum process conditions were found to be the following: Q (G) = 1.0 (L/min), C (oil) = 1,290 (mg/L), TMP = 1.58 (bar), and Q (L) = 3.0 (L/min). Under these optimal conditions, maximum permeate flux and rejection (%) were 115.9 (L/m(2)h) and 81.1 %, respectively.
Authors
I am an author on this paper
Click your name to claim this paper and add it to your profile.
Reviews
Recommended
No Data Available