Related references
Note: Only part of the references are listed.Radial two-phase thermal conductivity of ceramic sponges up to high temperatures - experimental results and correlation
T. Fischedick et al.
INTERNATIONAL JOURNAL OF THERMAL SCIENCES (2017)
Thermal conductivity of ceramic green bodies during drying
B. Nait-Ali et al.
JOURNAL OF THE EUROPEAN CERAMIC SOCIETY (2017)
Fabrication and properties of porous anorthite ceramics with modelling pore structure
Cuiwei Li et al.
MATERIALS LETTERS (2017)
The effect of mineralogy, microstructure and firing temperature on the effective thermal conductivity of traditional hot processing ceramics
Ignazio Allegretta et al.
APPLIED CLAY SCIENCE (2017)
Sintering temperature dependence of low-cost, low-density ceramic proppant with high breakage resistance
Xiaoxia Ma et al.
MATERIALS LETTERS (2016)
Review on the elaboration and characterization of ceramics refractories based on magnesite and dolomite
Chaouki Sadik et al.
JOURNAL OF ASIAN CERAMIC SOCIETIES (2016)
Mineralogical analysis of ceramic tiles by FTIR: A quantitative attempt
J. D. Jorda et al.
APPLIED CLAY SCIENCE (2015)
Recycling of lime mud and fly ash for fabrication of anorthite ceramic at low sintering temperature
Juan Qin et al.
CERAMICS INTERNATIONAL (2015)
FTIR spectral analysis and mechanical properties of sodium phosphate glass-ceramics
Paramjyot Kumar Jha et al.
JOURNAL OF MOLECULAR STRUCTURE (2015)
Investigation of the mechanism(s) controlling microwave sintering of α-alumina: Influence of the powder parameters on the grain growth, thermodynamics and densification kinetics
Fei Zuo et al.
JOURNAL OF THE EUROPEAN CERAMIC SOCIETY (2015)
Processing and properties of advanced porous ceramics: An application based review
E. C. Hammel et al.
CERAMICS INTERNATIONAL (2014)
How factors of land use/land cover, building configuration, and adjacent heat sources and sinks explain Urban Heat Islands in Chicago
Paul Coseo et al.
LANDSCAPE AND URBAN PLANNING (2014)
Humidity control porous ceramics prepared from waste and porous materials
Dinh-Hieu Vu et al.
MATERIALS LETTERS (2011)
Purification of diatomite powder by acid leaching for use in fabrication of porous ceramics
Osman San et al.
INTERNATIONAL JOURNAL OF MINERAL PROCESSING (2009)
Water retention properties of porous geopolymers for use in cooling applications
Kiyoshi Okada et al.
JOURNAL OF THE EUROPEAN CERAMIC SOCIETY (2009)
Water-retention properties of porous ceramics prepared from mixtures of allophane and vermiculite for materials to counteract heat island effects
Kiyoshi Okada et al.
CERAMICS INTERNATIONAL (2008)
Elaboration and characterisation of new mesoporous materials from diatomite and charcoal
H. Hadjar et al.
MICROPOROUS AND MESOPOROUS MATERIALS (2008)
Utilization of kaolin processing waste for the production of porous ceramic bodies
Romualdo R. Menezes et al.
WASTE MANAGEMENT & RESEARCH (2008)
Water absorption and retention of porous ceramics fabricated by waste resources
Tontoaki Kato et al.
JOURNAL OF THE CERAMIC SOCIETY OF JAPAN (2008)
Influence of the clay type on the pore structure of structural ceramics
S. Freyburg et al.
JOURNAL OF THE EUROPEAN CERAMIC SOCIETY (2007)
Preparation of filter aids based on diatomites
Sanja Martinovic et al.
INTERNATIONAL JOURNAL OF MINERAL PROCESSING (2006)
Sintering effect on cement bonded sewage sludge ash
CH Chen et al.
CEMENT & CONCRETE COMPOSITES (2006)
Sintering kinetics of porous ceramics from natural diatomite
XB Zhang et al.
JOURNAL OF THE AMERICAN CERAMIC SOCIETY (2005)
The relationship between attractive interparticle forces and bulk behaviour in dry and uncharged fine powders
A Castellanos
ADVANCES IN PHYSICS (2005)
Fabrication of highly porous mullite materials
R Barea et al.
JOURNAL OF THE AMERICAN CERAMIC SOCIETY (2005)
Mechanical recycling of waste electric and electronic equipment: a review
JR Cui et al.
JOURNAL OF HAZARDOUS MATERIALS (2003)
Share Paper
