The influence of shallow landslides on sediment supply: A flume-based investigation using sandy soil

The impact of rainfall-induced shallow landslides on hillslope sediment discharge is not well understood. This paper reports experimental measurements of sediment discharge after water-induced shallow landslides are triggered on sandy soil in a flume under simulated rainfall. The principal aim of the research was to investigate how varying soil depth affects the location and occurrence of shallow slope failures, as well as how it affects sediment yields downslope. Four experiments were conducted using the same sandy soil and a 30 degrees and 10 degrees compound slope configuration under average rainfall intensity of 50 mm h(-1) for up to 390 min. Soil depths were set to 200, 300, 400 and 500 mm. Engineering and geotechnical properties of the soil were examined. Sediment discharge and runoff were collected from the flume outlet at 15 minute intervals. Changes in the soil slope profiles after landslides and soil physical properties resulted from soil armouring, under continuous rainfall were also recorded. Results showed that sediment yields at the flume outlet, before landslides occurred, were very low and limited to the finer soil particles as would be expected for a sandy soil. However subsequent variations in sediment discharge were strongly related to failure events and their proximity to the outlet. Sediment yield was also affected by the original soil depth; the greater the depth, the higher the sediment yields. Post-failure reductions in sediment discharge were observed and attributed to post-failure slope stabilization under continuing rainfall and extensive soil armouring near the flume outlet. The results provide a clear linkage between landslides and sediment discharge due to hydrological processes occurring in the hillslope. This knowledge is being used to develop a model to predict sediment discharges from hillslopes following shallow landslide events. (C) 2009 Elsevier B.V. All rights reserved.