4.6 Article

Novel carbon-supported Fe-N electrocatalysts synthesized through heat treatment of iron tripyridyl triazine complexes for the PEM fuel cell oxygen reduction reaction

Journal

ELECTROCHIMICA ACTA
Volume 53, Issue 26, Pages 7703-7710

Publisher

PERGAMON-ELSEVIER SCIENCE LTD
DOI: 10.1016/j.electacta.2008.05.030

Keywords

catalyst carbon support; electrocatalyst; oxygen reduction reaction (ORR); iron (Fe)-nitrogen (N); 2,4,6-Tris(2-pyridyl)-1,3,5-triazine (TPTZ); heat (pyrolysis) treatment; proton exchange membrane (PEM) fuel cell

Funding

  1. Institute for Fuel Cell Innovation, National Research Council of Canada (NRC-IFCI)
  2. Conselho Nacional de Desenvolvimento Cientifico e Tecnologico, Brazil [202353/2006-0]
  3. CNPq [505167/2004-2]
  4. FINEP [520186-2005-2]

Ask authors/readers for more resources

2,4,6-Tris(2-pyridyl)-1,3,5-triazine (TPTZ) was used as a ligand to prepare iron-TPTZ(Fe-TPTZ) complexes for the development of a new oxygen reduction reaction (ORR) catalyst. The prepared Fe-TPTZ complexes were then heat-treated at temperatures ranging from 400 degrees C to 1100 degrees C to obtain carbon-supported Fe-N catalysts (Fe-N/C). These catalysts were characterized in terms of catalyst composition, structure, and morphology by several instrumental methods such as energy dispersive X-ray, X-ray diffraction, transmission electron microscopy, and X-ray photoelectron spectroscopy. With respect to the ORR activity, the Fe-NJC catalysts were also evaluated by cyclic voltammetry, as well as rotating disk and ring-disk electrodes. The results showed that among the heat-treated catalysts, that obtained at a heat-treatment temperature of 800 degrees C is the most active ORR catalyst. The overall electron transfer number for the catalyzed ORR was determined to be between 3.5 and 3.8, with 10-30% H2O2 production. The ORR catalytic activity of this catalyst was also tested in a hydrogen-air proton exchange membrane (PEM) fuel cell. At a cell voltage of 0.30V, this fuel cell can give a current density of 0.23 A cm(-2) with a maximum MEA power density of 0.070 W cm(-2) indicating that this catalyst has potential to be used as a non-noble catalyst in PEM fuel cells. Crown Copyright (c) 2008 Published by Elsevier Ltd. All rights reserved.

Authors

I am an author on this paper
Click your name to claim this paper and add it to your profile.

Reviews

Primary Rating

4.6
Not enough ratings

Secondary Ratings

Novelty
-
Significance
-
Scientific rigor
-
Rate this paper

Recommended

No Data Available
No Data Available