Evolution of the slab bending radius and the bending dissipation in three-dimensional subduction models with a variable slab to upper mantle viscosity ratio

Three-dimensional laboratory subduction models are presented investigating the influence of the slab/upper mantle viscosity ratio (eta(SP)/eta(UM)) on the slab bending radius (R-B), with eta(SP)/eta(UM)=66-1375. Here, R-B is non-dimensionalized by dividing it by the upper mantle thickness (T-UM). The results show that R-B/T-UM varies with time, reaching a maximum when the subduction velocity is maximum. Furthermore, R-B/T-UM increases approximately linearly with increasing eta(SP)/eta(UM) for the investigated viscosity range. The model results show that the slab bending force (F-Be) and the energy dissipation during bending (Phi(Be)) are small compared to the negative buoyancy force of the slab (F-Bu) and the potential energy release during sinking (Phi(Bu)). Maxima in Phi(Be)/Phi(Bu) (approximate to F-Be/F-Bu) are reached in the early stage of subduction when R-B/T-UM is minimum and the slab tip is at 220-440 km depth. Maximum Phi(Be)/Phi(Bu) increases with increasing eta(SP)/eta(UM), with Phi(Be)/Phi(Bu)(max) = 0.06. 0.11, 0.18 and 0.22 for eta(SP)/eta(UM) = 66, 217, 709 and 1375, respectively. Forsubduction depths >220-440 km, Phi(Be)/Phi(Bu)=0.02-0.11 forall viscosity ratios. Assuming that in nature eta(SP)/eta(UM) <1000, and that viscous dissipation during plan view curvature of the slab is <= 1%, the models predict that in nature most of the slab's potential energy is used to drive mantle flow (on average 88%-97% and minimally 81%), whilst only a small component is used to bend the subducting plate at the hinge (on average 2-11% and maximally 18%). Applying the model predictions for R-B/T-UM and Phi(Be)/Phi(Bu) to natural subduction zones implies that in nature eta(SP)/eta(UM) = 1-7 x 10(2) and eta(UM) = 0.8-2.7 x 10(20) Pa.s. Finally, the laboratory models, which use glucose syrup and silicone oil as modelling materials, highlight the importance of accurate control on temperature during an experiment New material investigations show that the viscosity of these two materials decreases exponentially with temperature in the range 3-33 degrees C their density decreases approximately linearly with temperature, and their coefficient of thermal volumetric expansion is 3.8-4.2 x 10(-4) C-1 (glucose syrup) and 9.2 x 10(-4) C-1 (silicone oil). (C) 2009 Elsevier B.V. All rights reserved.