Related references
Note: Only part of the references are listed.Drying of a Porous Material in a Pulsed Fluid Bed Dryer: The Influences of Temperature, Frequency of Pulsation, and Air Flow Rate
Marcello Nitz et al.
DRYING TECHNOLOGY (2009)
Drying sawdust in a pulsed fluidized bed
A. Reyes et al.
DRYING TECHNOLOGY (2008)
Influence of the bed mass on its fluidization characteristics
A Delebarre et al.
CHEMICAL ENGINEERING JOURNAL (2004)
The effect of agitated drying on the morphology of L-threonine (needle-like) crystals
A Lekhal et al.
INTERNATIONAL JOURNAL OF PHARMACEUTICS (2004)
Drying and heat transfer characteristics for a novel fluidized bed dryer
A Reyes et al.
DRYING TECHNOLOGY (2004)
Sticky region in drying - definition and identification
T Kudra
DRYING TECHNOLOGY (2003)
The drying of solids in a modified fluidized bed
MCB Ambrosio et al.
BRAZILIAN JOURNAL OF CHEMICAL ENGINEERING (2002)
Drying of waste sludges in a fluidized bed dryer with a mixer
J Adamiec
DRYING TECHNOLOGY (2002)
Pressure drop studies in bubble columns
BN Thorat et al.
INDUSTRIAL & ENGINEERING CHEMISTRY RESEARCH (2001)
Analysis of mechanically agitated fluid-particle contact dryers
A Reyes et al.
DRYING TECHNOLOGY (2001)
Effect of cohesive forces on fluidized and spouted beds of wet particles
ML Passos et al.
POWDER TECHNOLOGY (2000)
The design and performance of continuous well-mixed fluidized bed dryers - An analytical approach
CGJ Baker
DRYING TECHNOLOGY (2000)