Journal
COMPOSITES SCIENCE AND TECHNOLOGY
Volume 71, Issue 16, Pages 1834-1841Publisher
ELSEVIER SCI LTD
DOI: 10.1016/j.compscitech.2011.08.013
Keywords
Carbon fibre; Polymer-matrix composites (PMCs); Mechanical properties; Thermal properties; Sintering
Categories
Ask authors/readers for more resources
Aiming at developing carbon fibre/polyamide-12 (CF/PA) composite powders for manufacturing high-performance components by selective laser sintering (SLS), the preparation, characteristics and sintering process of the composite powders and mechanical properties of sintered components were studied. Surfaces of the carbon fibres were treated by the oxidation modification and coated with polyamide-12 through the dissolution-precipitation process to provide good interfacial adhesion and homogenous dispersion within the polyamide-12 matrix. The particle size and micro-morphology analyses show that the CF/PA composite powders with 30 wt%, 40 wt% and 50 wt% carbon fibres present the suitable powder sizes and format for SLS. The incorporation of carbon fibres into the polyamide-12 matrix decreases the initial melting temperature and consequently lowers the SLS part bed temperatures, implying lower energy requirement and less thermal degradation in the sintering process. The CF/PA composites also represent higher thermal stability than the pure polyamide-12. The CF/PA sintered components with 30 wt%, 40 wt% and 50 wt% carbon fibres exhibit the greatly enhanced flexural strengths by 44.5%, 83.3%, 114%, and the flexural modulus by 93.4%, 129.4%, 243.4%, respectively, as compared with the pure polyamide-12 sintered parts. Fractured surface analysis shows that the carbon fibres are encapsulated and bonded well with the polyamide matrix. The complex SLS parts with the thinnest wall of 0.6 mm, the density of 1.09 +/- 0.02 g/cm(3) and the relatively density of 94.13 +/- 1.72% were manufactured using the CF/PA composite powder with 30 wt% carbon fibres. This study demonstrates that the CF/PA composite powders prepared by the surface treatment and dissolution-precipitation method represent suitable interfacial adhesion, filler dispersion, particle sizes and sintering behaviours for SLS and enable the manufacture of complex components with high performance. (C) 2011 Elsevier Ltd. All rights reserved.
Authors
I am an author on this paper
Click your name to claim this paper and add it to your profile.
Reviews
Recommended
No Data Available