Journal
COMPOSITES SCIENCE AND TECHNOLOGY
Volume 71, Issue 13, Pages 1529-1534Publisher
ELSEVIER SCI LTD
DOI: 10.1016/j.compscitech.2011.06.001
Keywords
Debonding; Interface; Interfacial strength; Finite element analysis (FEA); Microbond test
Categories
Funding
- Technology Strategy Board, UK
Ask authors/readers for more resources
The microbond test was used to measure the interfacial shear strength (IFS) between a polyamide fibre and a water-based polyurethane. Due to the low viscosity of the water based polyurethane, the droplet could not be formed using a conventional preparation method. A disc shaped microbond droplet forms when an aqueous-based colloidal polymer adhesive was deposited onto the pin hole in a mounting card with a vertical polyamide fibre in the middle after drying and curing at an elevated temperature. Since the droplets were formed with a disc shape, which differs from the conventional ellipsoid, a finite element analysis of the stress distribution at the interface for these contrastingly shaped droplets were calculated and compared. The stress analysis showed that the interfacial shear stress profiles were well matched for both providing confidence that the disc-shaped droplets could be used for interfacial analysis. The microbond test using a disc-shaped droplet was used to study the influences of silane treatment and plasma treatment on the interfacial shear strength between a polyamide fibre and an aqueous deposited polyurethane. The interfacial shear strength of the fibre after plasma treatment was 10.3 MPa, much higher than that of the control and the silanised fibres, 5.2 MPa and 5.4 MPa respectively. The results showed that the microbond test could be used to investigate the interfacial properties of the polyamide fibre and water-based polymer adhesive. (C) 2011 Elsevier Ltd. All rights reserved.
Authors
I am an author on this paper
Click your name to claim this paper and add it to your profile.
Reviews
Recommended
No Data Available