Influence of RF power on structural, morphology, electrical, composition and optical properties of Al-doped ZnO films deposited by RF magnetron sputtering

In this study, influence of RF power on the structural, morphology, electrical, composition and optical properties of Al-doped ZnO (ZnO:Al) films deposited by RF magnetron sputtering have been investigated. Films were systematically and carefully investigated by using variety of characterization techniques such as low angle X-ray diffraction, UV-visible spectroscopy, Raman spectroscopy, Hall measurement, X-ray photoelectron spectroscopy, field emission scanning electron microscopy (FE-SEM), energy-dispersive X-ray spectroscopy etc. Low angle X-ray diffraction analysis showed that the films are polycrystalline with hexagonal wurtzite structure and which was further confirmed by Raman spectroscopy analysis. Its preferred orientation shifts from (102) to (002) with increase in RF power. The average grain size was found in the range of 15-21 nm over the entire range of RF power studied. The FE-SEM analysis showed that grain size and surface roughness of ZnO:Al films increase in with increase in RF power. The UV-visible spectroscopy analysis revealed that all films exhibit transmittance > 85 % in the visible region. The optical band gap increases from 3.37 to 3.85 eV when RF power increased from 75 to 225 W. Hall measurements showed that the minimum resistivity has been achieved for the film deposited at 200 W. The improvement in the electrical properties may attribute to increase in the carrier concentration and Hall mobility. Based on the experimental results, the RF power of 200 W appears to be an optimum sputtering power for the growth of ZnO:Al films. At this optimum sputtering power ZnO:Al films having minimum resistivity (8.61 x 10(-4) Omega-cm), highly optically transparent (similar to 87 %) were obtained at low substrate temperature (60 A degrees C) at moderately high deposition rate (22.5 nm/min). These films can be suitable for the application in the flexible electronic devices such as TCO layer on LEDs, solar cells, TFT-LCDs and touch panels.