4.7 Article

Flocculation properties of biodegradable amphoteric chitosan-based flocculants

Journal

CHEMICAL ENGINEERING JOURNAL
Volume 172, Issue 1, Pages 287-295

Publisher

ELSEVIER SCIENCE SA
DOI: 10.1016/j.cej.2011.05.106

Keywords

Amphoteric chitosan-based flocculants; Flocculation properties; Flocculation mechanism; Laboratory scale; Pilot scale

Funding

  1. Key Natural Science Foundation of China [51073077, 50633030]
  2. Ministry of Housing and Urban-Rural Development of China [2009-K7-11]
  3. Fundamental Research Funds for the Central Universities [1105020504]

Ask authors/readers for more resources

In this study, a kind of amphoteric chitosan-based flocculants (3-chloro-2-hydroxypropyl trimethyl ammonium chloride (CTA) modified carboxymethyl chitosan, denoted as CMC-CTA) have been prepared. The amphoteric flocculants showed notable improvement in solubility and salt-resistance in the whole pH range compared with its precursors, i.e., chitosan and cationic chitosan. The flocculation properties of CMC-CTA were systematically studied at both the laboratory and pilot scales. At laboratory scale, kaolin suspension was employed as synthetic water in the beaker experiment. The effects of pH, temperature, and original turbidity of untreated water on the dosage and flocculation performances were investigated, respectively. At pH below and above the isoelectric point of CMC-CTA, the optimal flocculation performances were obtained with a dosage of 0.03-0.20 mg/L and 0.8-1.0 mg/L, respectively. The flocculation mechanism was discussed in detail from the morphologies of polymeric flocculants and flocculation kinetics: The shape and charge of polymer chains in the solution greatly influenced the final flocculation performances; The flocculation kinetics agreed well with the particle collision model. Moreover, raw water from the Zhenjiang part of the Yangtze River in China was used for the further investigation of the flocculation properties at the pilot scale. The influences of dosage, sedimentation time, and mechanical mixing rate to the flocculation properties were studied by orthogonal testing. The optimal experimental condition was then obtained. Compared with the currently used flocculants in the Zhenjiang Water Factory, i.e., polyferric sulfate, which has an optimal dosage around 40 mg/L, the value of CMC-CTA (1.1 mg/L) decreased greatly. Above all, the flocculation experiments at the laboratory and pilot scales both indicate that the amphoteric chitosan-based flocculants have good flocculation performances in a wide pH range. (C) 2011 Elsevier B.V. All rights reserved.

Authors

I am an author on this paper
Click your name to claim this paper and add it to your profile.

Reviews

Primary Rating

4.7
Not enough ratings

Secondary Ratings

Novelty
-
Significance
-
Scientific rigor
-
Rate this paper

Recommended

No Data Available
No Data Available