Employment of factorial design for optimization of pirolisys and atomization temperatures for Al, Cd, Mo and Pb determination by ETAAS

This work describes a factorial design for the optimization of pyrolysis and atomization temperatures in ETAAS, As examples, Cd and Pb were determined using lower pyrolysis and atomization temperatures and Al and Mo with higher pyrolysis and atomization temperatures. Good results were obtained for Cd employing Rh (m(o) = 1.4 pg) as a permanent modifier with pyrolysis and atomization temperatures of 640 and 1500 degreesC, respectively. For Zr, W or Zr+W, the Cd pyrolysis and atomization temperatures were 500 and 1500 degreesC, respectively, with m. = 1.4 pg using Zr or W and 1.5 pg using Zr+W. The best results for Pb were those using Rh, Zr, W and Zr+Rh, obtaining characteristic masses of 42, 37, 34 and 36 pg, respectively, Pyrolysis and atomization temperatures of 910 and 1850 degreesC, respectively, were achieved for this metal. For Al, the best results were obtained when Zr or Zr+W were used. Mo was also tested as a possible permanent modifier for Al, but the results were not satisfactory. The results obtained for Mo without modifier were similar to those with conventional modifiers (Mg or Pd+Mg) and the results obtained using permanent chemical modifiers were not satisfactory. In all situations, the experiments were performed faster than those using the univariate procedure.