Quality of infrared dried apple slices

The aim of this work was to compare quality of apple slices dried by near infrared heating and convection in such parameters in which final material temperature in both methods was similar. The infrared drying was done at the distance between the emitters (with total power of 7.875 kW/m(2)) and heated surface equal to 10, 20, and 30 cm. Flow of ambient air was set at 0.5, 1.0, and 1.5 m/s. Convective drying was done in the same dryer using hot air at 65 and 75 degrees C flowing with velocity 1.5 m/s. Quality attributes measured in this work included: color, kinetics of water adsorption, mechanical properties, and microstructure. It was stated that the changes in chromaticity coefficients are not dependent on the mode of heat supply, but are related to the final temperature of the dried material. Luminance of dried apple slices was affected by temperature as well. Final material temperature, not the way heat is supplied, could be responsible for the differences in the ability of dry apple slices to adsorb water. The similar correlation was stated for mechanical properties: slope of initial part of the deformation curve (crispness), breaking force (hardness or crispness), and work of breaking were all related to the final material temperature. Microstructure of convective and infrared dried apple were different but it seems that the drying rate can be responsible for observed differences.