Australian Zn-Pb-Ag ore-forming systems: A review and analysis

Zn-Pb-Ag mineral deposits are the products of hydrothermal ore-forming systems, which are restricted in time and space. In Australia, these deposits formed during three main periods at similar to 2.95, 1.69 to 1.58, and 0.50 to 0.35 Ga. The 1.69 to 1.58 Ga event, which accounts for over 65 percent of Australia's Zn, was triggered by accretion and rifting along the southern margin of Rodinia. Over 93 percent of Australia's Zn-Pb-Ag resources were produced by four ore-forming system types: Mount Isa (56% of Zn), Broken Hill (19%), volcanic-hosted massive sulfide (VHMS; 12%), and Mississippi Valley (8%). Moreover, just 4 percent of Australia's land mass produced over 80 percent of its Zn. The four main types of ore-forming systems call be divided into two clans, based on fluid composition, temperature, and redox state. The Broken Hill- and VHMS-type deposits formed from high-temperature (>200 degrees C) reduced fluids, whereas the Mount Isa- and Mississippi Valley-type deposits formed from low-temperature (<200 degrees C), H2S-poor, and/or oxidized fluids. The tectonic setting and composition of the basins that host the ore-forming systems determine these fluid compositions and, therefore, the mineralization style. Basins that produce higher temperature fluids form in active tectonic environments, generally rifts, where high heat flow produced by magmatism drives convective fluid circulation. These basins are dominated by immature siliciclastic and volcanic rocks with a high overall abundance of Fe2+. The high temperature of the convective fluids combined with the abundance of Fe2+ in the basin allow inorganic sulfate reduction and leaching, of sulfide from the country rock, producing reduced, H2S-rich fluids. Basins that produce low-temperature fluids are tectonically less active, generally intracratonic, extensional basins dominated by carbonate and variably mature siliciclastic facies with a relatively low Fe2+ abundance. In these basins, sediment maturity depends oil the paleogeography and stratigraphic position in an accommodation cycle. Volcanic units, if present, occur in the basal parts of the basins. Because these basins have relatively low heat flow, convective fluid flow is less important, and fluid migration is dominated by expulsion of basinal brines in response to local and/or regional tectonic events. Low temperatures and the lack of Fe2+ prevent inorganic sulfate reduction during regional fluid flow, producing H2S-poor fluids that are commonly oxidized (i.e, Sigma SO4 > Sigma H2S). Fluid flow in the two basin types produces contrasting regional alteration systems. High-temperature fluidrock reactions in siliciclastic-volcanic-dominated basins produce semiconformable albite-hematite-epidote assemblages, but low-temperature reactions in carbonate-siliciclastic-dominated basins produce regional K-feldspar-hematite assemblages. The difference in feldspar mineralogy is mostly a function of temperature. In both basin types, regional alteration zones have lost, and probably were the source of, Zn and Pb. The contrasting fluid types require different depositional mechanisms and traps to accumulate metals. The higher temperature, reduced VHMS- and Broken Hill-type fluids deposit metals as a consequence of mixing with cold seawater. Mineralization occurs at or near the sea floor, with trapping efficiencies enhanced by subsurface replacement or deposition in a brine pool. In contrast, the low-temperature, oxidized Mount Isa- and Mississippi Valley-type fluids precipitate metals through thermochemical sulfate reduction facilitated by hydrocarbons or organic matter. This process can occur at depth in the rock pile, for instance in failed petroleum traps, or just below the sea floor in pyritic, organic-rich muds.