Related references
Note: Only part of the references are listed.Encapsulated Copper Wire and Copper Mesh Capacitive Sensing for 3-D Printing Applications
Corey Shemelya et al.
IEEE SENSORS JOURNAL (2015)
3D Printing multifunctionality: structures with electronics
David Espalin et al.
INTERNATIONAL JOURNAL OF ADVANCED MANUFACTURING TECHNOLOGY (2014)
Novel ABS-based binary and ternary polymer blends for material extrusion 3D printing
Carmen R. Rocha et al.
JOURNAL OF MATERIALS RESEARCH (2014)
Fracture Surface Analysis of 3D-Printed Tensile Specimens of Novel ABS-Based Materials
Angel R. Torrado Perez et al.
JOURNAL OF FAILURE ANALYSIS AND PREVENTION (2014)
Effect of particle size, filler loadings and x-ray tube voltage on the transmitted x-ray transmission in tungsten oxide-epoxy composites
N. Z. Noor Azman et al.
APPLIED RADIATION AND ISOTOPES (2013)
Ohmic Curing of Printed Silver Conductive Traces
D. A. Roberson et al.
JOURNAL OF ELECTRONIC MATERIALS (2012)
Microstructural characterization of electrically failed conductive traces printed from Ag nanoparticle inks
David A. Roberson et al.
MATERIALS LETTERS (2012)
Integrating stereolithography and direct print technologies for 3D structural electronics fabrication
Amit Joe Lopes et al.
RAPID PROTOTYPING JOURNAL (2012)
Multi-material, multi-technology stereolithography This feature article covers a decade of research into tackling one of the major challenges of the stereolithography technique, which is including multiple materials in one construct
Ryan B. Wicker et al.
VIRTUAL AND PHYSICAL PROTOTYPING (2012)
Terahertz Characterization of Single-Walled Carbon Nanotube and Graphene On-Substrate Thin Films
Min Liang et al.
IEEE TRANSACTIONS ON MICROWAVE THEORY AND TECHNIQUES (2011)
Silane coupling agents used for natural fiber/polymer composites: A review
Yanjun Xie et al.
COMPOSITES PART A-APPLIED SCIENCE AND MANUFACTURING (2010)
Effects of particle size, particle/matrix interface adhesion and particle loading on mechanical properties of particulate-polymer composites
Shao-Yun Fu et al.
COMPOSITES PART B-ENGINEERING (2008)
Microwave (8-50 GHz) characterization of multiwalled carbon nanotube papers using rectangular waveguides
Lu Wang et al.
IEEE TRANSACTIONS ON MICROWAVE THEORY AND TECHNIQUES (2008)
The thermal degradation of bisphenol A polycarbonate containing methylphenyl-silicone additive
Wenjun Zhou et al.
JOURNAL OF ANALYTICAL AND APPLIED PYROLYSIS (2007)
Structural and mechanical properties of polymer nanocomposites
S. C. Tjong
MATERIALS SCIENCE & ENGINEERING R-REPORTS (2006)
Mesoscale RF relay enabled by integrated rapid manufacturing
J. A. Palmer et al.
RAPID PROTOTYPING JOURNAL (2006)
The thermal degradation of bisphenol A polycarbonate in air
BN Jang et al.
THERMOCHIMICA ACTA (2005)
Tensile performance improvement of low nanoparticles filled-polypropylene composites
CL Wu et al.
COMPOSITES SCIENCE AND TECHNOLOGY (2002)
Structure-property relationships of irradiation grafted nano-inorganic particle filled polypropylene composites
MZ Rong et al.
POLYMER (2001)