Membrane fouling in a submerged membrane bioreactor (SMBR): Characterisation of the sludge cake and its high filtration resistance

The attachment of sludge cake to the membrane surface is the main cause of the fouling problem in the submerged membrane bioreactors (SMBR) used in biological wastewater treatment. In this laboratory study, the sludge cake deposited on the membrane was found to have a specific filtration resistance of the order of 10(14) m/kg, which is much greater than expected for sludge cake formed during the dewatering of activated sludge. The filterability tests showed that the cake sludge removed from the fouled membrane of the SMBR had an average specific filtration resistance of 4.9 x 10(13) m/kg, whereas the sludge cake of the SMBR bulk sludge had an average filtration resistance of only 1.9 x 10(11) m/kg. Detailed chemical analysis showed there was a pool of biopolymer clusters (BPC) that was trapped within the sludge cake on the membrane. These clusters could be readily separated from the cake sludge by stirring it into a suspension. The abundance of non-filterable BPC as measured by the total organic carbon (TOC) in the suspended solids (SS) was about 10.3 mg/g SS for the cake sludge, in comparison to 0.4 mg/g SS for the bulk sludge. When the BPC were removed from the cake sludge, the filtration resistance of the cake sludge could be reduced considerably from 4.9 x 10(13) to 8.4 x 10(12) m/kg. It is argued that the BPC are a special form of organic matter formed by affinity clustering of the free extracellular polymeric substances (EPS) and soluble microbial products (SMP) in the sludge cake deposited on the membrane surface. The accumulation of BPC within the pores of the sludge cake is mostly responsible for the unusually high filtration resistance of the cake sludge during the SMBR operation. (c) 2006 Elsevier B.V. All rights reserved.