The impact of pre-existing gas on the ascent of explosively erupted magma

Most, if not all, magmas contain gas bubbles at depth before they erupt. Those bubbles play a crucial role in eruption dynamics, by allowing magma to degas, which causes the magma to accelerate as it ascends towards the surface. There must be a limit to that acceleration, however, because gas bubbles cannot grow infinitely fast. To explore that limit, a series of experiments was undertaken to determine the maximum rate at which bubbly high-silica rhyolite can decompress. Rhyolite melt that was hydrated at 150 MPa with similar to 5.3 wt.% dissolved water and contained 7 to 18 vol.% bubbles can degas in equilibrium at 875A degrees C when decompressed at rates up to 1.2 MPa s(-1) from 150 to 78 MPa, and up to 1.8 MPa s(-1) when decompressed further to 42 MPa. In contrast, that same rhyolite cannot degas in equilibrium at 750A degrees C if decompressed faster than 0.015-0.025 MPa s(-1). When combined with other published experiments, the maximum rate of decompression for equilibrium degassing is found to increase by a factor of ten for every 50-75A degrees C increase in temperature. When compared to predictions from conduit flow models that assume equilibrium degassing, it is found that such models greatly over-estimate the rate at which relatively cold rhyolite can decompress, whereas that assumption is largely correct for hot rhyolite, and thus for most other magmas, all of which are less viscous than rhyolite. In addition, most bubbles that were 20-30 A mu m in size at high pressure were lost from the population at low pressure. That absence suggests that only relatively large vesicles seen in volcanic pumice may be relics of pre-eruptive bubbles, even if small bubbles were originally present at depth.