4.8 Article

Electricity generation from polyalcohols in single-chamber microbial fuel cells

Journal

BIOSENSORS & BIOELECTRONICS
Volume 24, Issue 4, Pages 849-854

Publisher

ELSEVIER ADVANCED TECHNOLOGY
DOI: 10.1016/j.bios.2008.07.015

Keywords

Microbial fuel cell; Polyalcohol; Lignocellulosic biomass; Electricity generation; Microbial community

Funding

  1. U.S. Department of Transportation

Ask authors/readers for more resources

Six polyalcohols derived from lignocellulosic carbohydrates were investigated as carbon sources for electricity generation in single-chamber mediator-less microbial fuel cells (MFCs) for the first time. Electricity was directly generated from all polyalcohols tested, including pentitols (xylitol, arabitol, and ribitol) and hexitols (galactitol, mannitol, and sorbitol). Bacterial cultures initially enriched using acetate could be adapted to these substrates with varied adaptation times. The resultant maximum power density ranged from 1490 +/- 160 mW/m(2) to 2650 +/- 10 mW/m(2) at current densities between 0.58 mA/cm(2) and 0.78 mA/cm(2). Galactitol generated the highest maximum power density, while mannitol resulted in the lowest one. The estimated maximum voltage output at an external resistance of 120 Q ranged between 0.24 V and 0.34 V with half saturation kinetic constants varied from 298 mg/L to 753 mg/L The removal of chemical oxygen demand (COD) was above 91% for all polyalcohols except sorbitol (71%). Denaturing gradient gel electrophoresis (DGGE) of PCR-amplified 16S rRNA gene segments of the anode biofilms showed the influence of substrates (polyalcohols) on the anode microbial populations. (C) 2008 Elsevier B.V. All rights reserved.

Authors

I am an author on this paper
Click your name to claim this paper and add it to your profile.

Reviews

Primary Rating

4.8
Not enough ratings

Secondary Ratings

Novelty
-
Significance
-
Scientific rigor
-
Rate this paper

Recommended

No Data Available
No Data Available