4.7 Article

Normal and Shear Forces between Surfaces Bearing Porcine Gastric Mucin, a High-Molecular-Weight Glycoprotein

Journal

BIOMACROMOLECULES
Volume 12, Issue 4, Pages 1041-1050

Publisher

AMER CHEMICAL SOC
DOI: 10.1021/bm101369d

Keywords

-

Funding

  1. Biological and Biotechnology Research Council (U.K.)
  2. Unilever plc
  3. Charles W. McCutchen Foundation
  4. European Research Council
  5. Petroleum Research Fund [45694-AC7]

Ask authors/readers for more resources

A surface force balance was used to measure the normal and shear, forces between two mica surfaces each bearing an adsorbed layer of porcine gastric mucin (Orthana mucin), genetically similar to. human MUC6. This mucin is a highly purified, 546 kDa, weakly negative, polyampholytic molecule with a dumbbell structure. Both bare (HP) and hydrophobized (HB) mica substrates were used, and forces were measured under 1 and 30 mg/mL mucin solutions, under pure (no-added-salt) water, and under 0.1 M aqueous Na+ solution. Normal surface forces were monotonically repulsive in all cases, with onset of repulsion occurring at smaller surface separations, D, in the 0.1 M salt solutions (similar to 20 nm, compared with similar to 40 nm for no added salt). Repulsion on RP mica was greater on surface compression. than decompression, an effect, attributed to bridging and slow-relaxing additional adsorption on compression, not seen on HB mica, a difference attributed to the denser coverage of mucin hydrophobic moieties on the HB surface, Friction forces increased with compression in all cases, showing hysteretic behavior on HP but not on HB mica, commensurate with the hysteresis observed in the normal measurements. Low friction coefficients mu (= partial derivative F-s/partial derivative F-n < 0.05) were seen up to mean pressures (P) approximate to 0.5 to 1.0 MPa; attributed to low interpenetration of the opposed layers together with hydration lubrication effects, With higher (up to 0.4) at higher (P) attributed to interlayer entanglements and to bridging (for the case of HP mica);Shear forces increased only weakly with sliding speed over the range investigated (80-820 nm s(-1)). The lower friction with FIB relative to HP mica suggests a Selectivity of the HB surface to the hydrophobic moieties of the mucin that in consequence exposes relatively, more of the better-lubricating hydrophilic groups. This surface-selectivity effect on lubrication may have a generality extending to other biological macromolecules that contain both hydrophilic and hydrophobic groups.

Authors

I am an author on this paper
Click your name to claim this paper and add it to your profile.

Reviews

Primary Rating

4.7
Not enough ratings

Secondary Ratings

Novelty
-
Significance
-
Scientific rigor
-
Rate this paper

Recommended

No Data Available
No Data Available