4.3 Article

Direct fluorination of toluene using elemental fluorine in gas/liquid microreactors

Journal

JOURNAL OF FLUORINE CHEMISTRY
Volume 105, Issue 1, Pages 117-128

Publisher

ELSEVIER SCIENCE SA
DOI: 10.1016/S0022-1139(00)00300-6

Keywords

fluorination; toluene; elemental fluorine; falling film microreactor; micro bubble column

Ask authors/readers for more resources

Direct fluorination of toluene, pure or dissolved in either acetonitrile or methanol, using elemental fluorine was investigated in gas/liquid microreactors, namely a falling film microreactor and a micro bubble column. The experiments included measurements at high substrate concentrations and at high fluorine contents diluted in a nitrogen carrier gas, e.g. up to 50 vol.% fluorine. Results obtained were compared to the performance of a laboratory bubble column which served as a technological benchmark. Due to the formation of liquid layers of only a few tens of micrometers thickness, the microreactors provide very large interfacial areas, e.g. up to 40,000 m(2)/m(3). These values exceed by far those of the laboratory bubble column as well as all other devices applied in practice. The potential for enhancing mass and heat transfer was verified by several experiments resulting in an increase in conversion and selectivity for the microreactors compared to the laboratory benchmark. For the falling film microreactor, yields of up to 28% of monofluorinated ortho and para products for a degree of toluene conversion of 76% were obtained. These values are of the same order as described for the industrially applied Schiemann process. Space-time yields of the microreactors, when referred to the reaction channel volume, were orders of magnitude higher than those of the laboratory bubble column. Taking into account the construction material needed, the corresponding figures of merit, for an idealized geometry as well as the existing total reactor geometry, still indicate technological and economic benefits. A variation of operating conditions for the direct fluorination revealed that conversion can be increased in the microreactors by using higher fluorine-to-toluene ratios and reaction temperatures. The choice of solvent is also essential, with acetonitrile yielding much better results than methanol. (C) 2000 Elsevier Science S.A. All rights reserved.

Authors

I am an author on this paper
Click your name to claim this paper and add it to your profile.

Reviews

Primary Rating

4.3
Not enough ratings

Secondary Ratings

Novelty
-
Significance
-
Scientific rigor
-
Rate this paper

Recommended

No Data Available
No Data Available