High-resolution adsorption isotherms of supercritical carbon dioxide on activated carbon

Supercritical fluids are attractive solvents for heterogeneous processes, including catalysis and adsorptive separation. However, adsorption processes in the near-critical region are poorly understood and exhibit unique behavior where the adsorption of the supercritical solvent plays an important role in the solute adsorption. The behavior of supercritical fluids in confined pores has been studied theoretically, but there are few experimental darn on their behavior in industrially important microporous materials. The adsorption of carbon dioxide on Calgon F400 activated carbon over a wide range of pressures (0 -20 MPa) at temperatures near the critical point of carbon dioxide (30 to 45 degrees C) was studied. Near-continuous adsorption and desorption isotherms were measured with a new flow gravimetric apparatus with precise control over pressure and temperature. As pressure is increased, the excess adsorption increases sharply at low pressures; then a broad maximum is observed At temperatures greater than the critical temperature, there is a sharp drop in excess adsorption near the critical region where the density of the bulk fluid increases sharply. A crossover is observed near the critical region where, below a certain pressure, the excess adsorption decreases with temperature, while above the crossover point the trend is reversed When analyzed as a function of solvent density, the crossover disappears, revealing an anomalous maximum in total adsorption near the critical point similar to the enhanced local density or charisma observed in binary solute - supercritical fluid systems. A 2-D EOS model using the 2-D Peng-Robinson EOS was able to qualitatively describe the adsorption behavior over the entire pressure range, but the quantitative agreement was poor in the near-critical region.