4.7 Article

High-resolution mass spectrometry analysis of secondary organic aerosol generated by ozonolysis of isoprene

Journal

ATMOSPHERIC ENVIRONMENT
Volume 44, Issue 8, Pages 1032-1042

Publisher

PERGAMON-ELSEVIER SCIENCE LTD
DOI: 10.1016/j.atmosenv.2009.12.019

Keywords

Biogenic aerosol; SOA; Gas-particle partitioning; Peroxides; Carbonyls; Organic carbon; Oligomers

Funding

  1. NSF [ATM-0831518, CHE-0909227]
  2. Camille & Henry Dreyfus Foundation
  3. U.S. Department of Energy [DE-AC06-76RL0 1830]
  4. Direct For Mathematical & Physical Scien
  5. Division Of Chemistry [0909227, GRANTS:13931825] Funding Source: National Science Foundation
  6. Directorate For Geosciences [0831518] Funding Source: National Science Foundation
  7. Div Atmospheric & Geospace Sciences [0831518] Funding Source: National Science Foundation

Ask authors/readers for more resources

The chemical composition of secondary organic aerosol (SOA) generated from the ozonolysis of isoprene (C5H8) in the presence of an OH scavenger was examined using high-resolution electrospray ionization mass spectrometry (ESI-MS) in the mass range m/z = 50-1000. The chemical composition of SOA is complex, with more than 1000 assigned peaks observed in the positive and negative ion mode spectra. Only a small fraction of peaks correspond to known products of isoprene oxidation, such as pyruvic acid, glycolic acid, methylglyoxal, etc. The absolute majority of the detected peaks correspond to highly oxidized oligomeric constituents of SOA, with an average OX molar ratio of 0.6. The corresponding organic mass (OM) to organic oxygen (00) ratio is 2.4. Approximately 8% of oxygen atoms in SOA are in the form of peroxides, as quantified with an iodide test. Double bond equivalency (DBE) factors, representing the sum of all double bonds and rings, increase by 1 for every 1-2 additional carbon atoms in the molecule. The number of unoxidized C=C double bonds is estimated to be less than 10%; the remaining DBE is due to C=O carbonyl groups. Kendrick analysis suggests that the prevalent oligomer building blocks are small carbonyls with a C-1-C-2 skeleton. Formaldehyde (CH2O) is identified as the most common repetitive building block in the observed oligomeric compounds. (C) 2009 Elsevier Ltd. All rights reserved.

Authors

I am an author on this paper
Click your name to claim this paper and add it to your profile.

Reviews

Primary Rating

4.7
Not enough ratings

Secondary Ratings

Novelty
-
Significance
-
Scientific rigor
-
Rate this paper

Recommended

No Data Available
No Data Available