Measuring the hydraulic, conductivity of shallow submerged sediments

The hydraulic conductivity of submerged sediments influences the interaction between ground water and surface water, but few techniques for measuring K have been described with the, conditions of the submerged setting in mind. Two simple, physical methods for measuring the hydraulic conductivity of submerged sediments have been developed, and one of them uses a well and piezometers similar to well tests performed in terrestrial aquifers. This test is based on a theoretical analysis that uses a constant-head boundary condition for the upper surface of the aquifer to represent the effects of the overlying water body. Existing analyses of tests used to measure the hydraulic conductivity of submerged sediments may contain errors from using the same upper boundary conditions applied to simulate terrestrial aquifers. Field implementation of the technique requires detecting minute drawdowns in the vicinity of the pumping well. Low-density oil was used in an inverted U-tube manometer to amplify the head differential so that it could be resolved in the field. Another technique was developed to measure the vertical hydraulic conductivity of sediments at the interface with overlying surface water. This technique uses the pan from a seepage meter with a piezometer fixed along its axis (a piezo-seep meter). Water is pumped from the pan and the head gradient is measured using the axial piezometer. Results from a sandy streambed indicate that both methods provide consistent and reasonable estimates of K. The pumping test allows skin effects to be considered, and the field data show that omitting the skin effect (e.g., by using a single well test) can produce results that underestimate the hydraulic conductivity of streambeds.