Increase of Pd surface area by treatment in dioxygen

The surface area of Pd(111) and Pd(110) single crystals increased after oxidation in O-2 transformed them to PdO. The surface area of the oxide decreased after complete reduction in H-2. The techniques of STM, TPD, XPS, AES, and LEED were employed to study the Pd(111) and Pd(110) single-crystal surfaces after they were subjected to O-2 oxidation, methane combustion, and H-2 reduction. The surface area of the treated palladium single crystals was measured by O-18 isotope exchange and by direct measurements using the STM image. These two methods showed agreement within 20%. After oxidation in O-2 (100 and 150 Torr) at 600 K, the surface area for both Pd(111) and Pd(110) single crystals increased by a factor of approximately two. The effect was more pronounced on the Pd(111) surface. The oxidized surfaces were covered with 3- to 4-nm semispherical oxide agglomerates that formed a cauliflower-like structure 10-20 nm in size. Similar surface structures were observed after exposure of the Pd single crystals to a lean O-2 and CH4 reaction mixture (O-2:CH4 = 10:1). Thus, the oxidized single crystal becomes amorphous. Reduction in H2 decreased the surface area of the preoxidized Pd(111) and Pd(110) crystals. An amorphous metallic surface was produced after H-2 reduction at 373 K, whereas a smooth surface with characteristic single-crystal features was observed after reduction at 673 K. These experiments suggest that oxidizing a Pd metal catalyst or reducing an oxidized Pd catalyst, for example, before palladium metal surface area measurement, will affect the surface area of the sample. It also shows that the increase in surface area on Pd catalysts after oxidation treatment is caused by surface roughening. (C) 2004 Elsevier Inc. All rights reserved.