Effect of molding temperature on crystalline and phase morphologies of HDPE composites containing PP nano-fibers

A high-density polyethylene (HDPE)/isotactic polypropylene (PP) (75/25) blend containing 25 wt% of PP was fibrillated by roller drawing at 138 degreesC. The fibrillated blend was processed again at temperatures ranging from 155 to 200 degreesC by compression molding or extrusion. The effects of molding temperature on the morphology and mechanical properties of the blend were investigated. Wide angle X-ray scattering (WAXS) and transmission electron microscopy (TEM) were used to study the morphology of the samples. The roller-drawn blend exhibited a fibrous structure with the chain direction aligned parallel to the drawing direction. After molding at 155 degreesC, the HDPE formed parallel-stacked lamellae retaining the parallel orientation after the melting of the PE crystals. As the molding temperature increased the parallel orientation gradually vanished and some of the parallel-stacked lamellae changed into twisted lamellae. The PP phase existed as fibrils in the PE matrix and the crystals stayed with their molecular chain aligned parallel to the fibrillation direction even when the molding temperature was far above the melting temperature of PP. Nevertheless, the orientation of the crystals did not change as the molding temperature increased from 155 to 165 degreesC. The internal structure of the PP fibrils changed from a needle structure to a parallel-stacked one. The PP fibrils induced the crystallization of the PE melt, leading to the formation of a trans-crystalline layer at their surface. As the molding temperature increased, more PE lamellae protruded into the PP fibrils and the interface between the PP fibrils and the PE matrix became diffuse. (C) 2004 Elsevier Ltd. All rights reserved.