Related references
Note: Only part of the references are listed.Inkjet Printing-Process and Its Applications
Madhusudan Singh et al.
ADVANCED MATERIALS (2010)
Waveform Design Methods for Piezo Inkjet Dispensers Based on Measured Meniscus Motion
Kye-Si Kwon
JOURNAL OF MICROELECTROMECHANICAL SYSTEMS (2009)
Evaluation of jet performance in drop-on-demand (DOD) inkjet printing
Byoung Wook Jo et al.
KOREAN JOURNAL OF CHEMICAL ENGINEERING (2009)
Influence of Fluid Physical Properties on Ink-Jet Printability
Daehwan Jang et al.
LANGMUIR (2009)
Droplet Tailoring Using Evaporative Inkjet Printing
Jolke Perelaer et al.
MACROMOLECULAR CHEMISTRY AND PHYSICS (2009)
Filament stretching rheometry and break-up behaviour of low viscosity polymer solutions and inkjet fluids
T. R. Tuladhar et al.
JOURNAL OF NON-NEWTONIAN FLUID MECHANICS (2008)
Spreading of an inkjet droplet on a solid surface with a controlled contact angle at low weber and Reynolds numbers
Yangsoo Son et al.
LANGMUIR (2008)
A waveform design method for high-speed inkjet printing based on self-sensing measurement
Kye-Si Kwon et al.
SENSORS AND ACTUATORS A-PHYSICAL (2007)
Visualization of drop-on-demand inkjet: Drop formation and deposition
Hongming Dong et al.
REVIEW OF SCIENTIFIC INSTRUMENTS (2006)
An experimental study of drop-on-demand drop formation
Hongming Dong et al.
PHYSICS OF FLUIDS (2006)
Inkjet printing of polymers: State of the art and future developments
BJ de Gans et al.
ADVANCED MATERIALS (2004)
Numerical and experimental comparisons of mass transport rate in a piezoelectric drop-on-demand inkjet print head
DY Shin et al.
INTERNATIONAL JOURNAL OF MECHANICAL SCIENCES (2004)
Development of a three-dimensional simulation system for micro-inkjet and its experimental verification
HC Wu et al.
MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING (2004)
Inkjet printing of highly loaded particulate suspensions
B Derby et al.
MRS BULLETIN (2003)
Inkjet printing of light-emitting polymer displays
T Shimoda et al.
MRS BULLETIN (2003)
Fine-line conductor manufacturing using drop-on-demand PZT printing technology
JB Szczech et al.
IEEE TRANSACTIONS ON ELECTRONICS PACKAGING MANUFACTURING (2002)
Ink-jet printing of wax-based alumina suspensions
KAM Seerden et al.
JOURNAL OF THE AMERICAN CERAMIC SOCIETY (2001)
Controlling droplet deposition with polymer additives
V Bergeron et al.
NATURE (2000)