High technology catalysts towards 100% selectivity fabrication, characterization and reaction studies

Catalysis in the 20th century focused primarily on activity, increasing turnover rates to produce more molecules per unit time. High selectivity was of lesser concern because disposal of undesirable byproducts was not costly and raw materials were abundant. This has changed in the 21st century because waste disposal is now expensive and the negative ecological impacts are well-documented. As a result, the present focus and roadmap of catalysis science is to achieve high selectivity in all catalyst-based chemical processes. Our knowledge of the molecular ingredients that influence selectivity is poor compared to our understanding of activity. There are six identifiable features that influence both catalyst activity and selectivity. They are metal surface structure, bonding modifier additives, mobility of metal clusters to restructure as well as the mobility of adsorbates on these clusters, selective site blocking, bifunctionality, and oxide-metal interface sites. Identification of the molecular ingredients of catalyst activity and selectivity provides opportunity for catalyst design, combined catalyst synthesis, characterization and reaction studies. In order to obtain high selectivity towards the ultimate goal of 100% selectivity, synthetic methods that enable molecular control over the size, location, structure of the metallic nanoparticles and catalyst promoters must be developed. We are attempting to do this by fabricating two- and three-dimensional catalysts. Two-dimensional nanoparticle or nanowire array catalysts are fabricated by electron beam lithography (EBL) or size reduction lithography (SRL). Arrays with metal surface areas of about I mm(2) or 10(9) nanoparticles are fabricated by EBL. These model catalyst systems enable the study of high-turnover reactions such as ethylene hydrogenation. SRL and a lithographic polymer imprinting technique are used to produce nanowire or nanodot array model catalysts with metallic surface areas up to I cm(2) or 10(11) nanoparticles. High surface area (1 m(2) Or 10(15) nanoparticles) is produced by a one-step method in which polymer-stabilized monodisperse nanoparticles are synthesized in solution and incorporated into high-surface area mesoporous silica mechanically or through hydrothermal synthesis. Both types of model catalysts are characterized by a variety of physical and chemical techniques and are catalytically active for hydrocarbon conversion test reactions. Our catalyst design approach combines synthesis (fabrication), characterization and reaction studies. (c) 2004 Elsevier B.V. All rights reserved.