Performance and combustion characteristics of biodiesel-diesel-methanol blend fuelled engine

An experimental investigation was conducted to evaluate the effects of using methanol as additive to biodiesel-diesel blends on the engine performance, emissions and combustion characteristics of a direct injection diesel engine under variable operating conditions. BD50 (50% biodiesel and 50% diesel in vol.) was prepared as the baseline fuel. Methanol was added to BD50 as an additive by volume percent of 5% and 10% (denoted as BDM5 and BDM10). The results indicate that the combustion starts later for BDM5 and BDM10 than for BD50 at low engine load, but is almost identical at high engine load. At low engine load of 1500 r/min, BDM5 and BDM10 show the similar peak cylinder pressure and peak of pressure rise rate to BD50, and higher peak of heat release rate than that of BD50. At low engine load of 1800 r/min, the peak cylinder pressure and the peak of pressure rise rate of BDM5 and BDM10 are lower than those of BD50, and the peak of heat release rate is similar to that of BD50. The crank angles at which the peak values occur are later for BDM5 and BDM10 than for BD50. At high engine load, the peak cylinder pressure, the peak of pressure rise rate and peak of heat release rate of BDM5 and BDM10 are higher than those of BD50, and the crank angle of peak values for all tested fuels are almost same. The power and torque outputs of BDM5 and BDM10 are slightly lower than those of BD50. BDM5 and BDM10 show dramatic reduction of smoke emissions. CO emissions are slightly lower, and NO, and HC emissions are almost similar to those of BD50 at speed characteristic of full engine load. (C) 2009 Elsevier Ltd. All rights reserved.