Removal of humic matter interference in the determination of Cr(VI) in soil extracts by the diphenylcarbazide method

Alkaline digestion of soil samples, which is recommended for minimizing Cr(III)-Cr(VI) interconversions during the extraction of Cr(VI), may also solubilize humic matter (HM). The latter is responsible for both positive and negative interference in the analysis of Cr(VI) in the extract by the diphenylcarbazide (DPC) method. Humic compounds indeed absorb light at 540 nm as the Cr-DPC product and are also able to rapidly reduce Cr(VI) under the pH conditions of the standard DPC method. To prevent any risk of interference and make the DPC method applicable to soil extracts, a new protocol is proposed. This consists of three successive steps: (1) extraction of Cr(VI) by the U.S.EPA method 3060A in the presence of Mg2+; (2) batch removal of solubilised HM by the XAD-7 sorbent at pH 3.0 +/- 0.1 with 3-5 min contact time; (3) analysis of Cr(VI) with the DPC method at pH 3.0 +/- 0.1. The application of this new protocol to the soil product SQC-012 Lot 4 certified by R.T. Corporation (RTC, USA) gave significantly lower Cr(VI) concentrations and smaller variability compared to certified values (46.5 +/- 2.3 instead of 153 +/- 32.6 mg/kg). The new protocol was validated by Cr(VI) and Cr(III) spikes either to the soil/extractant suspension or to the exctract. Cr(VI) results in the wide range of acceptance limits (104-202mg/kg) reported by RTC were only obtained when the U.S.EPA method 3060A without the addition of Mg2+ and DPC analysis at pH 1.0 were applied. The latter procedure appears questionable since it leads to largely variable results which reflect the complex role played by humic matter in the determination of Cr(VI) and the instability of Cr(III) during the extraction. (c) 2005 Elsevier B.V. All rights reserved.