4.8 Article

Selective reduction of NO with CO in the presence of O2 with Ir/WO3 catalysts: Influence of preparation variables on the catalytic performance

Journal

APPLIED CATALYSIS B-ENVIRONMENTAL
Volume 84, Issue 3-4, Pages 783-789

Publisher

ELSEVIER SCIENCE BV
DOI: 10.1016/j.apcatb.2008.06.011

Keywords

Selective catalytic reduction; Nitrogen monoxide; Iridium catalyst; Tungsten oxide support; Lean-burn condition

Ask authors/readers for more resources

Several Ir/WO3 catalysts were prepared, which were different in the loading of Ir (up to 10 wt.%) and in the pretreatment conditions, and used for the reduction of NO (500 ppm) with CO (3000 ppm) in the presence of excess O-2 (5%). SO2 (2 ppm), and H2O (1%). The rate of NO conversion per unit mole of Ir was found to be maximal at a small It loading of 0.5-1.0 wt.%. The good catalytic performance was achieved when the it precursors (IrOx) supported on WO3 Were reduced under mild conditions by He at 400 degrees C or H-2/He at a lower temperature of 130 degrees C. The catalysts were characterized by XRD, FTIR after CO adsorption, and H-2-TPR. The characterization results show that the active sites are exposed zero-valent Ir species, in accordance with previous works using it on WO3 and other supports, and that the fraction of these active species is larger for a higher degree of It dispersion (smaller It particles). The preparation conditions for highly active Ir/WO3 Catalysts were confirmed and possible reaction mechanisms were discussed. (C) 2008 Elsevier B.V. All rights reserved.

Authors

I am an author on this paper
Click your name to claim this paper and add it to your profile.

Reviews

Primary Rating

4.8
Not enough ratings

Secondary Ratings

Novelty
-
Significance
-
Scientific rigor
-
Rate this paper

Recommended

No Data Available
No Data Available