4.6 Article

Structure of alumina supported vanadia catalysts for oxidative dehydrogenation of propane prepared by flame spray pyrolysis

Journal

APPLIED CATALYSIS A-GENERAL
Volume 451, Issue -, Pages 207-215

Publisher

ELSEVIER SCIENCE BV
DOI: 10.1016/j.apcata.2012.09.037

Keywords

Flame spray pyrolysis; Vanadia; Oxidative dehydrogenation; Propane; Propene; Nanoparticle

Funding

  1. BMBF [05K10VKB]
  2. Danish Council for Strategic Research (DSF) [2106-08-0039]
  3. DTU
  4. DANSCAT
  5. EU [RII13-CT-2004-506008]

Ask authors/readers for more resources

A series of five vanadia on alumina catalysts for oxidative dehydrogenation of propane to propene were synthesized by flame spray pyrolysis (FSP) using vanadium(III)acetylacetonate and aluminium(III)acetylacetonate dissolved in toluene as precursors. The vanadium loading was 2, 3, 5, 7.5 and 10 wt.%. The catalysts were subsequently characterized by BET surface area, X-ray diffraction (XRD), Raman, UV-vis diffuse reflectance and X-ray absorption spectroscopy (XAS) as well as measurement of the catalytic performance. The catalysts had specific surface areas from 143 to 169 m(2)/g corresponding to average particles diameters from 9.0 to 10.9 nm and apparent vanadia surface densities from 1.4 to 8.4 VOx/nm(2). The only crystalline phase detected by XRD was gamma-Al2O3, except at 10 wt.% vanadium where traces of crystalline vanadia were observed. Raman spectroscopy showed vanadia monomers at 2 and 3 wt.% V (1.4 and 2.1 VOx/nm(2)), a mixture of vanadia oligomers and monomers at 5 wt.% V (3.6 VOx/nm(2)) and mainly oligomers at 7.5 and 10 wt.% V (6.0 and 8.4 VOx/nm(2)). Diffuse reflectance UV vis and extended X-ray absorption fine structure (EXAFS) spectroscopy measurements supported the results of Raman spectroscopy. In situ X-ray absorption near edge structure (XANES) spectroscopy showed that the vanadia can be reduced when operating at low oxygen concentrations. The catalyst performance was determined in fixed bed reactors with an inlet gas composition of C3H8/O-2/N-2 = 5/25/70. The main products were propene, CO and CO2, with traces of ethene and acrolein. Comparing propene selectivity as function of propane conversion the most selective catalysts were the 2 and 3 wt.% V samples, which contained mostly vanadia monomers according to Raman spectroscopy. The best propene yield of 12% was obtained with the 2 wt.% vanadium catalyst while the best space time yield of 0.78 g(propene)/(g(cat).h) at 488 degrees C was obtained with the 3 wt.% V catalyst. (C) 2012 Elsevier B.V. All rights reserved.

Authors

I am an author on this paper
Click your name to claim this paper and add it to your profile.

Reviews

Primary Rating

4.6
Not enough ratings

Secondary Ratings

Novelty
-
Significance
-
Scientific rigor
-
Rate this paper

Recommended

No Data Available
No Data Available