Silica supported tungsta-zirconia catalysts for hydroisomerization-cracking of long alkanes

New acidic materials with fairly uniform mesoporous texture were synthesized by deposition of tungsten promoted zirconia (WZ) over a wide pore silica carrier (SiO2). High dispersion of the tungsten-zirconia crystallites was achieved by a two-step controlled impregnation procedure. A first deposition of zirconia was performed by controlled hydrolysis of alkoxide. impregnation of tungstate was performed by incipient wetness impregnation of ammonium metatungstate. The catalysts show an activation pattern for the reaction of 1-butene similar to bulk tungsten-zirconia catalyst, with an optimum at a calcination temperature of 750 degrees C. Supported zirconia crystallizes almost exclusively as tetragonal crystallites. The catalysts were tested in the reaction or hydroisomerization-cracking of n-octane (300 degrees C, 1 atm, WHSV = 1 h(-1) and H-2/n-C-8 = 6 mol/mol) for the production of light isoalkanes (isobutane, isopentane, isohexane) of high octane number. The tried catalysts had a high catalytic activity and this result was related to the high surface area of the supported catalyst. Both bulk and supported catalysts deactivated rapidly if they did not contain Pt. Impregnation with Pt and the use of H-2 in the reaction medium enable the hydrogenation of coke precursors and the stabilization of the catalyst. A stable performance was obtained at a moderate activity level. This was attributed to the presence of Pt/SiO2 particles with a stronger metal function than Pt/WZ due to a lower metal-support interaction. Silica supported catalysts would have a higher hydrogenating activity and this would be crucial for enhancing their stability in comparison to bulk Pt/WZ catalysts. Tungsten addition to supported zirconia in amounts greater than 7.5% produced segregation of a WO3 phase in the form of crystallites that plugged pores and produced a reduction of the available area and hence of the overall catalytic activity. For the WZ supported catalysts activity as a function of calcination temperature had a pattern similar to that of bulk WZ catalysts. Supported WZ catalysts were more stable in the n-octane isomerization reaction and reached a pseudo steady state even at very low H-2 partial pressures while bulk WZ catalysts deactivated continuously and stabilized only at high H-2 partial pressures. on a mass basis of active WZ phase some supported catalysts had a higher activity than bulk WZ. They also have a more open pore structure more suitable for the reaction of bulky molecules. However the dilution effect of silica produces catalysts with a relatively low activity per unit volume. (C) 2008 Elsevier B.V. All rights reserved.