Drinking spout orifice size affects licking behavior in inbred mice

Using a lickometer, we assessed the effect of drinking spout orifice size on the licking behavior of inbred mice [C57BL/6J, SWR/J, 129P3/J and DBA/2J]. Animals licked from drinking spout sipper tubes that had what were defined as either a large (2.7 mm) or a small (1.5 mm) orifice. Mice took approximately twice as many licks from a stationary single small orifice drinking spout than when licking from a spout with a large orifice during separate 30-min sessions. However, their total intake volume was approximately the same. We calculated that mice received a mean of 0.55 mu L per lick from the drinking tubes with a small orifice and a mean of 1.15 mu L per lick from the drinking tubes with a large orifice. Thus, the animals appear to have regulated their fluid intake by proportionally adjusting their licking as a function of the lick volume. On average, this regulation occurred through modulation of the size of licking bursts and not their frequency. However, strain differences in compensation strategy were observed. When licking was restricted to a series of 5-s trials in a 30-min brief access test session, the smaller orifice size increased the range of responsiveness that was expressed. Mice increased their average licks per trial by 20% and took 60% more trials when licking from a spout with a small orifice. Interestingly, when the orifice size was quasi-randomly varied within a brief access session, licking was greater from large orifice drinking spouts, suggesting that water delivered from the two orifice sizes differs in its reinforcement efficacy. These findings demonstrate that drinking spout orifice size can significantly influence experimental outcomes in licking tests involving mice and care should be taken in controlling this variable in testing the effects of taste or other factors on ingestive behavior. (c) 2005 Elsevier Inc. All rights reserved.