Influence of culture parameters on biological hydrogen production by Clostridium saccharoperbutylacetonicum ATCC 27021

Various medium components (carbon and nitrogen sources, iron, inoculum size) and environmental factors (initial pH and the agitation speed) were evaluated for their effects on the rate and the yield of hydrogen production by Clostridium saccharoperbutylacetonicum. Among the carbon sources assessed, cells grown on disaccharides (lactose, sucrose and maltose) produced on the average more than twice (2.81 mol-H-2/mol sugar) as much hydrogen as monosaccharides (1.29 mol-H-2/mol sugar), but there was no correlation between the carbon source and the production rate. The highest yield (2.83 mol/mol) was obtained in lactose and sucrose but the highest production rate (1.75 mmol/h) in sucrose. Using glucose as carbon source, yeast extract was the best nitrogen source. A parallel increase between the production rate and the yield was obtained by increasing glucose concentration up to 40 g/l (1.76 mol-H-2/mol, 3.39 mmol/h), total nitrogen as yeast extract up to 0.1% (1.41 mol/mol, 1.91 mmol/h) and agitation up to 100 rev/min (1.66 mol-H-2/mol, 1.86 mmol/h). On the other hand, higher production rates were favoured in preference to the yield at a neutral initial pH 7 (2.27 mmol/h), 1000 mg iron/l or more (1.99 mmol/h), and a larger inoculum size, 10%, (2.36 mmol/h) whereas an initial alkaline pH of 8.5 (1.72 mol/mol), a lower iron concentration of 25 mg/l (1.74 mol/mol) and smaller inoculum size, 1%, (1.85 mol/mol) promoted higher yield over production rate.