4.3 Article

Skeletal muscle ATP turnover and muscle fiber conduction velocity are elevated at higher muscle temperatures during maximal power output development in humans

Publisher

AMER PHYSIOLOGICAL SOC
DOI: 10.1152/ajpregu.00291.2005

Keywords

cycling exercise; temperature coefficient; myosin heavy chain; surface electromyography; energy production

Categories

Ask authors/readers for more resources

Skeletal muscle ATP turnover and muscle fiber conduction velocity are elevated at higher muscle temperatures during maximal power output development in humans. Am J Physiol Regul Integr Comp Physiol 290: R376 - R382, 2006. First published September 15, 2005; doi: 10.1152/ ajpregu. 00291.2005. The effect of temperature on skeletal muscle ATP turnover and muscle fiber conduction velocity ( MFCV) was studied during maximal power output development in humans. Eight male subjects performed a 6- s maximal sprint on a mechanically braked cycle ergometer under conditions of normal ( N) and elevated muscle temperature ( ET). Muscle temperature was passively elevated through the combination of hot water immersion and electric blankets. Anaerobic ATP turnover was calculated from analysis of muscle biopsies obtained before and immediately after exercise. MFCV was measured during exercise using surface electromyography. Preexercise muscle temperature was 34.2 degrees C ( SD 0.6) in N and 37.5 degrees C ( SD 0.6) in ET. During ET, the rate of ATP turnover for phosphocreatine utilization [ temperature coefficient ( Q(10)) = 3.8], glycolysis (Q(10) = 1.7), and total anaerobic ATP turnover [Q(10) = 2.7; 10.8 ( SD 1.9) vs. 14.6 mmol (.) kg(-1) (dry mass)(.)s(-1) (SD 2.3)] were greater than during N (P < 0.05). MFCV was also greater in ET than in N [3.79 ( SD 0.47) to 5.55 m/s (SD 0.72)]. Maximal power output (Q(10) = 2.2) and pedal rate (Q(10) = 1.6) were greater in ET compared with N (P < 0.05). The Q(10) of maximal and mean power were correlated (P < 0.05; R = 0.82 and 0.85, respectively) with the percentage of myosin heavy chain type IIA. The greater power output obtained with passive heating was achieved through an elevated rate of anaerobic ATP turnover and MFCV, possibly due to a greater effect of temperature on power production of fibers, with a predominance of myosin heavy chain IIA at the contraction frequencies reached.

Authors

I am an author on this paper
Click your name to claim this paper and add it to your profile.

Reviews

Primary Rating

4.3
Not enough ratings

Secondary Ratings

Novelty
-
Significance
-
Scientific rigor
-
Rate this paper

Recommended

No Data Available
No Data Available