Temperature distribution in adiabatic shear band for ductile metal based on JOHNSON-COOK and gradient plasticity models

Gradient-dependent plasticity considering interactions and interplay among microstructures was included into JOHNSON-COOK model to calculate the temperature distribution in adiabatic shear band(ASB), the peak and average temperatures as well as their evolutions. The differential local plastic shear strain was derived to calculate the differential local plastic work and the temperature rise due to the microstructural effect. The total temperature in ASB is the sum of initial temperature, temperature rise at strain-hardening stage and non-uniform temperature due to the microstructural effect beyond the peak shear stress. The flow shear stress-average plastic shear strain curve, the temperature distribution, the peak and average temperatures in ASB are computed for Ti-6A1-4V When the imposed shear strain is less than 2 and the shear strain rate is 1 000 s(-1), the dynamic recovery and recrystallization processes occur. However, without the microstructural effect, the processes might have not occurred since heat diffusion decreases the temperature in ASB. The calculated maximum temperature approaches 1500 K so that phase transformation might take place. The present predictions support the previously experimental results showing that the transformed and deformed ASBs are observed in Ti-6Al-4V Higher shear strain rate enhances the possibility of dynamic recrystallization and phase transformation.