Optimization of extraction of phenolic compounds from flax shives by pressurized low-polarity water

Pressurized low-polarity water (PLPW) extraction of phenolic compounds from flax shive was investigated using statistically based optimization and the one-factor-at-a-time method. Extraction variables examined using central composite design (CCD) included temperature, flow rate, and NaOH concentration of the extracting water. Extraction of phenolic compounds including p-hydroxybenzaldehyde, vanillic acid, syringic acid, vanillin, acetovanillone, and feruric acid was affected by temperature and NaOH concentration; and extraction of all phenolic compounds, except ferulic acid, increased with temperature and NaOH concentration of the extracting water. Flow rate had little effect on concentration of phenolic compounds at equilibrium, but the extraction rate at the early phase was higher for higher flow rates. The mechanism of PLPW extraction of flax shive phenolics was also investigated using a two-site kinetic model and a thermodynamic model. To determine the extraction mechanism, flow rate was varied from 0.3 to 4.0 mL/min while temperature and NaOH concentration were fixed at 180 degrees C and 0.47 M, respectively. The flow rate tests showed the extraction rates of total phenolic (TP) compounds increased with flow rate and can be described by a thermodynamic model. The results from the thermodynamic model demonstrated that a K D value of 30 agreed with the experimental data in the flow rate range of 0.3-4.0 mL/min. When the effect of the three independent variables was evaluated simultaneously using CCD, a maximum TP concentration of 5.8 g/kg of dry flax shive (DFS) was predicted from the combination of a high temperature (230.5 degrees C), a high initial concentration of NaOH (0.63 M), and a low flow rate (0.7 mL/ min). Maximum TP concentration of 5.7 g/kg of DFS was obtained from extraction conditions of 180 degrees C, 0.3 or 0.5 mL/ min, and 0.47 M NaOH at equilibrium. A second-order regression model generated by CCD predicted a maximum TP concentration of 5.8 g/kg of DFS under the same extraction conditions, which is well matched with the results from experimental data.