Journal
ACTA MATERIALIA
Volume 55, Issue 3, Pages 1083-1091Publisher
PERGAMON-ELSEVIER SCIENCE LTD
DOI: 10.1016/j.actamat.2006.09.027
Keywords
equal-channel angular pressing; extrusion; magnesium alloys; severe plastic deformation; superplasticity
Ask authors/readers for more resources
The microstructures and properties of a two-phase Mg-8% Li alloy were evaluated in three different conditions: after casting; after casting followed by extrusion at different temperatures and speeds; and after casting, extrusion and processing by ECAP for four passes at room temperature using a die with a channel angle of 135 degrees. The results show extrusion introduces significant grain refinement and there is additional refinement in ECAP. In tensile testing, the elongations to failure increase with decreasing extrusion temperature, but are essentially independent of the extrusion speed. The ductilities are low in the cast condition, intermediate in the extruded condition and high after extrusion and ECAP. For the last condition, an exceptionally high elongation of similar to 1780% was achieved at a testing temperature of 473 K. It is shown that it is advantageous to use a die with a channel angle of 135 degrees because it permits pressing at room temperature where grain growth is limited. (C) 2006 Acta Materialia Inc. Published by Elsevier Ltd. All rights reserved.
Authors
I am an author on this paper
Click your name to claim this paper and add it to your profile.
Reviews
Recommended
No Data Available