4.7 Article

States of carbon nanotube supported Mo-based HDS catalysts

Journal

FUEL PROCESSING TECHNOLOGY
Volume 88, Issue 2, Pages 117-123

Publisher

ELSEVIER
DOI: 10.1016/j.fuproc.2004.08.010

Keywords

carbon nanotubes; XRD; TPR; HDS; LRS

Ask authors/readers for more resources

As HDS catalysts, the supported catalysts including oxide state Mo, Co-Mo and sulfide state Mo on carbon nanotube (CNT) were prepared, while the corresponding supported catalysts on gamma-Al2O3 were prepared as comparison. Firstly, the dispersion of the active phase and loading capacity of Mo species on CNT was studied by XRD and the reducibility properties of Co-Mo catalysts in oxide state over CNTs were investigated by TPR while the sulfide Co-Mo/CNT catalysts were characterized by XRD and LRS techniques. Secondly, the activity and selectivity of hydrodesulfurization (HDS) of dibenzothiophene with Co-Mo/CNT and Co-Mo/gamma-Al2O3 were studied. It has been found that the main active molybdenum species in the oxide state MoO3/CNT catalysts were MoO2, rather than MoO3 as generally expected. The maximum loading before formation of the bulk phase was lower than 6%m (calculated in MoO3). The TPR studies revealed that that active species in oxide state Co-Mo/CNT catalysts were more easily reduced at relatively lower temperatures in comparison to those in Co-Mo/gamma-Al2O3, indicating that the CNT support promoted the reduction of active species. Among 0-1.0 Co/Mo atomic ratio on Co-Mo/CNT, 0.7 has the highest reducibility. It shows that the Co/Mo atomic ratio has a great effect on the reducibility of active species on CNT and their HDS activities and that the incorporation of cobalt improved the dispersion of molybdenum species on CNT and mobilization. It was also found that re-dispersion could occur during the sulfiding process, resulting in low valence state Mo3S4 and Co-MoS2.17 active phases. The HDS of DBT showed that Co-Mo/CNT catalysts were more active than Co-Mo/gamma-Al2O3 and the hydrogenolysis/hydrogenation selectivity of Co-Mo/CNT catalyst was also much higher than Co-Mo/gamma-Al2O3. For the Co-Mo/CNT catalysis system, the catalyst with Co/Mo atomic ratio of 0.7 showed the highest activity, whereas, the catalyst with Co/Mo atomic ratio of 0.35 was of the highest selectivity. (C) 2006 Elsevier B.V. All rights reserved.

Authors

I am an author on this paper
Click your name to claim this paper and add it to your profile.

Reviews

Primary Rating

4.7
Not enough ratings

Secondary Ratings

Novelty
-
Significance
-
Scientific rigor
-
Rate this paper

Recommended

No Data Available
No Data Available