Injectable hyaluronic acid microhydrogels for controlled release formulation of erythropoietin

An injectable hyaluronic acid (HA) microhydrogel was successfully developed as a novel drug carrier for controlled release formulation of protein drugs. HA hydrogels were prepared by the disulfide bond formation of thiolated HA (HA-SH). EPO was loaded in situ during HA-SH hydrogel preparation using an accelerating agent of sodium tetrathionate. The gelation time was drastically reduced from a day to 30 min when sodium tetrathionate was added for HA-SH hydrogel preparation. In vitro release of EPO in PBS at 37 degrees C showed that EPO was rapidly released for 3 days with an initial burst and then slowly up to 9 days from HA-SH hydrogels. HA-SH microhydrogels were prepared by the reactive spray drying of diluted HA-SH precursor solution. The mean particle size was similar to 2.3 mu m and the water content after spray drying was similar to 14%. Ellman's test showed that sodium tetrathionate contributed not only for rapid crosslinking reaction but also for the reduction of residual free thiol content in HA-SH microhydrogels after spray drying. EPO recovery from HA-SH microhydrogels after degradation with hyaluronidase SD was higher than 95%. The released EPO appeared to be intact from the analysis with RP-HPLC. According to in vivo release test of EPO from HA-SH microhydrogels in Sprague Dawley (SD) rats, elevated plasma concentration of EPO higher than 0.1 ng/mL, which is a critical minimal concentration for EPO efficacy, was maintained up to 7 days. There was no adverse effect during and after the in vivo tests. (c) 2006 Wiley Periodicals, Inc.