4.6 Article

Role of surface state on the electron flow in modified TiO2 film incorporating carbon powder for a dye-sensitized solar cell

Journal

ELECTROCHIMICA ACTA
Volume 52, Issue 16, Pages 5242-5250

Publisher

PERGAMON-ELSEVIER SCIENCE LTD
DOI: 10.1016/j.electacta.2007.02.038

Keywords

dye-sensitized solar cell; carbon-modified TiO2 electrode; electron transport; charge trapping; surface state

Funding

  1. Korea Institute of Industrial Technology(KITECH) [10006741] Funding Source: Korea Institute of Science & Technology Information (KISTI), National Science & Technology Information Service (NTIS)
  2. National Research Foundation of Korea [R11-2002-102-01002-0, 과C6A1903, R01-2004-000-10143-0] Funding Source: Korea Institute of Science & Technology Information (KISTI), National Science & Technology Information Service (NTIS)

Ask authors/readers for more resources

An investigation of surface-related traps in nanostructured TiO2 films modified by the incorporation of carbon powder was conducted by the potential-step chronoamperometric method. For the modification of the morphology and surface state of the nanoporous TiO2 electrode, the incorporation of carbon into the white TiO2 Powder was accomplished. In the chronoamperometric data, all of the transients showed an initial fast phase (< 1 s) followed by a slower phase which is related to the trap filling process. The trap-filling period of the carbon incorporated TiO2 film becomes longer, as the applied negative potential increases, due to the widely distributed traps induced by the increased surface area. Furthermore, the film capacitance was derived as a function of the applied bias by integrating the current to time curves of the chronoamperometric data. The accumulated charge of the carbon incorporated TiO2 film increases prominently in two regions. The dominant increase shown in the positive region (-0.7 to -0.9 V vs. Ag/AgCl at pH 13) of the flat band potential implies that the electron occupancy in the surface-related traps is increased. At a more negative potential (below - 1.2 V vs. Ag/AgCl), electrons from the conduction band of the TiO2 film substantially influence the total current, thereby inducing an exponential increase in the current. Therefore, it is found that most of the traps are located in the positive region of the flat band potential, since the Fermi level of the nanostructured TiO2 film is positioned at - 1.14 V vs. Ag/AgCl at pH 13. The trap sites in the sub-bandgap region of the TiO2 film are important in the electron transport of photoinjected electrons from dye molecules and partially charge recombination with redox electrolyte in operating dye-sensitized solar cell. The influence of charge trap formed by increased surface states on the electron transport and electron transfer was investigated by photovoltage and photocurrent transient measurements. (c) 2007 Elsevier Ltd. All rights reserved.

Authors

I am an author on this paper
Click your name to claim this paper and add it to your profile.

Reviews

Primary Rating

4.6
Not enough ratings

Secondary Ratings

Novelty
-
Significance
-
Scientific rigor
-
Rate this paper

Recommended

No Data Available
No Data Available