The effects of cavity size and incremental technique on micro-tensile bond strength of resin composite in class I cavities

Objective. The purpose of this study was to investigate if incremental-filling technique and cavity size would affect the bond strength of resin composite. Methods. Two sizes of Class I cavities were prepared in bovine dentin (large cavities: pi x (5/2)2 x 5 mm(3); small cavity: pi x (3/2)(2) x 3 mm(3)). Light-cure resin composite (Clearfil Photocore) with a self-etching primer adhesive (Clearfil SE Bond) was placed into the cavities by bulk filling (C-factor = 5) or incremental filling (two layers, C-factor = 3) and light-cured. As a control, 3 or 5 mm thick resin composite was bonded to the flat dentin surface. After 24 h storage in 37 degrees C water, the micro-tensile bond strength was measured at a crosshead speed of 1 mm/min. The results obtained were statistically analyzed using two-way ANOVA and t-test at a significance level of P = 0.05. Results. The results obtained showed that there was no significant difference among the filling techniques in small cavities (P > 0.05). However, in large cavities, bulk filling presented the lowest bond strength (P < 0.05). Significance. Not only the filling technique affected the bonding strength to the cavity floor, but the cavity size was also an influential factor in Class I cavities. (c) 2006 Academy of Dental Materials. Published by Elsevier Ltd. All rights reserved.