Laser induced-thermal lens spectrometry after cloud point extraction for the determination of trace amounts of rhodium

A new combination method, employing thermal lens spectrometry (TLS) after cloud point extraction (CPE), has been developed for the preconcentration and determination of rhodium. TLS and CPE methods have good matching conditions for the combination because TLS is a suitable method for the analysis of low volume samples obtained after CPE. Rhodium was complexed with 1-(2-pyridylazo)-2-naphthol (PAN) as a complexing agent in an aqueous medium and concentrated by octylphe-noxypolyethoxyethanol (Triton X-114) as a surfactant. After the phase separation at 50 degrees C based on the cloud point extraction of the mixture, the surfactant-rich phase was dried and the remaining phase was dissolved using 20 mu L of carbon tetrachloride. The obtained solution was introduced into a quartz micro cell and the analyte was determined by laser induced-thermal lens spectrometry (LI-TLS). The single laser TLS was used as a sensitive method for the determination of Rhodium-PAN complex in 20 mu L of the sample. Under optimum conditions, the analytical curve was linear for the concentration range of 0.5-50 ng mL(-1) and the detection limit was 0.06 ng mL(-1). The enhancement factor of 450 was achieved for 10 mL samples containing the analyte and relative standard deviations were lower than 5%. The developed method was successfully applied to the extraction and determination of rhodium in water samples. (c) 2007 Elsevier B.V. All rights reserved.