4.7 Article

Synthesis of Ag-deionized water nanofluids using multi-beam laser ablation in liquids

Journal

OPTICS AND LASERS IN ENGINEERING
Volume 45, Issue 12, Pages 1099-1106

Publisher

ELSEVIER SCI LTD
DOI: 10.1016/j.optlaseng.2007.06.005

Keywords

laser ablation in liquid; Ag-deionized water nanofluid

Categories

Ask authors/readers for more resources

Multi-pulse laser ablation of silver in deionized water was studied. The laser beams were arranged in a cross-beam configuration. In our experiments, two single-mode, Q-switched Nd-Yag lasers operating at 1064 nm, pulse duration of 5.5ns and 10Hz rep rate were used. The laser fluence of the second beam was 0.265 J/cm(2) for all tests. Two levels of the laser fluences were used for the ablating beam: 0.09 and 0.265 J/cm(2) (11,014 and 33,042 j/cm(2) at the focal point, respectively). The silver target was at 50 mm from the cell window and 10mm deep. The second beam was aligned parallelly with the silver target and focused at 2mm in front of the focal point of the ablating beam. For all cases, the delay time between the ablating beam and the cross-beam was 40 mu s. In general, the ablated particles were almost all spherical. For fluence of 0.09 J/cm(2) and single-beam approach, the mean particle size was about 29 nm. The majority of the particles, however, were in 19-35 nm range and there were some big ones as large as 50-60 nm in size. For double-beam approach, the particles were smaller with the average size of about 18 nm and the majority of the particles were in 9-21 nm range with few big one as large as 40nm. For the beam fluence of 0.265J/cm(2) and single-beam configuration, the particle sizes were smaller, the mean particles size was about 18 nm and the majority of the particles were in the range of 10-22 nm with some big one as large as 40 nm. For double-beam approach, the mean particle size was larger (24.2 nm) and the majority of the particle were distributed from 14 to 35 nm with some big particles can be found with sizes as big as 70nm. Preliminary measurements of the thermal conductivity and viscosity of the produced samples showed that the thermal conductivity increased about 3-5% and the viscosity increased 3.7% above the base fluid viscosity even with the particle volume concentration as low as 0.0 1%. Published by Elsevier Ltd.

Authors

I am an author on this paper
Click your name to claim this paper and add it to your profile.

Reviews

Primary Rating

4.7
Not enough ratings

Secondary Ratings

Novelty
-
Significance
-
Scientific rigor
-
Rate this paper

Recommended

No Data Available
No Data Available