Related references
Note: Only part of the references are listed.A bonded sphero-cylinder model for the discrete element simulation of elasto-plastic fibers
Yu Guo et al.
CHEMICAL ENGINEERING SCIENCE (2018)
Predicting breakage of high aspect ratio particles in an agitated bed using the Discrete Element Method
Y. Guo et al.
CHEMICAL ENGINEERING SCIENCE (2017)
Flow Properties of Spices Measured with Powder Flow Tester and Ring Shear Tester-XS
Katarina Slettengren et al.
INTERNATIONAL JOURNAL OF FOOD PROPERTIES (2016)
Precision of pharmaceutical powder flow measurement using ring shear tester: High variability is inherent to powders with low cohesion
Lap Yin Leung et al.
POWDER TECHNOLOGY (2016)
Discrete element modelling of flexible fibre packing
Paul Langston et al.
COMPUTATIONAL MATERIALS SCIENCE (2015)
Assessment on bulk solids best practice techniques for flow characterization and storage/handling equipment design for biomass materials of different classes
Diego Barletta et al.
FUEL PROCESSING TECHNOLOGY (2015)
Computational study of granular shear flows of dry flexible fibres using the discrete element method
Y. Guo et al.
JOURNAL OF FLUID MECHANICS (2015)
Assessment of Pharmaceutical Powder Flowability using Shear Cell-Based Methods and Application of Jenike's Methodology
Paul D. Jager et al.
JOURNAL OF PHARMACEUTICAL SCIENCES (2015)
A ring shear tester as calibration experiment for DEM simulations in agitated mixers - a sensitivity study
Tom A. H. Simons et al.
NEW PARADIGM OF PARTICLE SCIENCE AND TECHNOLOGY, PROCEEDINGS OF THE 7TH WORLD CONGRESS ON PARTICLE TECHNOLOGY (2015)
Approach to structural anisotropy in compacted cohesive powder
S. Strege et al.
GRANULAR MATTER (2014)
Granular shear flows of flat disks and elongated rods without and with friction
Y. Guo et al.
PHYSICS OF FLUIDS (2013)
Validation and time step determination of discrete element modeling of flexible fibers
Y. Guo et al.
POWDER TECHNOLOGY (2013)
Granular Shear Flows of Flexible Rod-like Particles
Y. Guo et al.
POWDERS AND GRAINS 2013 (2013)
Prediction of Bulk Powder Flow Performance Using Comprehensive Particle Size and Particle Shape Distributions
Weili Yu et al.
JOURNAL OF PHARMACEUTICAL SCIENCES (2011)
Calibration of discrete element parameters and the modelling of silo discharge and bucket filling
C. J. Coetzee et al.
COMPUTERS AND ELECTRONICS IN AGRICULTURE (2009)
Predicting the flow mode from hoppers using the discrete element method
William R. Ketterhagen et al.
POWDER TECHNOLOGY (2009)
Multi-scale simulation of needle-shaped particle breakage under uniaxial compaction
Zdenek Grof et al.
CHEMICAL ENGINEERING SCIENCE (2007)
Granular shear flows at the elastic limit
CS Campbell
JOURNAL OF FLUID MECHANICS (2002)
Share Paper
