Related references
Note: Only part of the references are listed.Effect of the friction riveting process parameters on the joint formation and performance of Ti alloy/short-fibre reinforced polyether ether ketone joints
J. Altmeyer et al.
MATERIALS & DESIGN (2014)
Microstructure and mechanical properties of friction spot welds of dissimilar AA5754 Al and AZ31 Mg alloys
U. Suhuddin et al.
MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING (2014)
Joint properties of dissimilar Al6061-T6 aluminum alloy/Ti-6%Al-4%V titanium alloy by gas tungsten arc welding assisted hybrid friction stir welding
HanSur Bang et al.
MATERIALS & DESIGN (2013)
Brazing of 6061 aluminum alloy/Ti-6Al-4V using Al-Si-Cu-Ge filler metals
S. Y. Chang et al.
JOURNAL OF MATERIALS PROCESSING TECHNOLOGY (2012)
An investigation on microstructure and mechanical properties of Al7075 to Ti-6Al-4V Transient Liquid Phase (TLP) bonded joint
M. S. Kenevisi et al.
MATERIALS & DESIGN (2012)
Preliminary Investigation of the Microstructure and Mechanical Behaviour of 2024 Aluminium Alloy Friction Spot Welds
Sergio T. Amancio-Filho et al.
MATERIALS TRANSACTIONS (2011)
Interfacial Microstructure and Mechanical Properties of Dissimilar Friction Stir Welds between 6061-T6 Aluminum and Ti-6%Al-4%V Alloys
Ki-Sang Bang et al.
MATERIALS TRANSACTIONS (2011)
Weld-bead profile and costs optimisation of the CO2 dissimilar laser welding process of low carbon steel and austenitic steel AISI316
A. Ruggiero et al.
OPTICS AND LASER TECHNOLOGY (2011)
Improving interfacial properties of a laser beam welded dissimilar joint of aluminium AA6056 and titanium Ti6Al4V for aeronautical applications
W. V. Vaidya et al.
JOURNAL OF MATERIALS SCIENCE (2010)
Interfacial reaction mode and its influence on tensile strength in laser joining Al alloy to Ti alloy
S. H. Chen et al.
MATERIALS SCIENCE AND TECHNOLOGY (2010)
Comprehensive analysis of joint strength for dissimilar friction stir welds of mild steel to aluminum alloys
Tsutomu Tanaka et al.
SCRIPTA MATERIALIA (2009)
Formation process of the bonding joint in Ti/Al diffusion bonding
Yao Wei et al.
MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING (2008)
Multi-response optimization of CO2 laser-welding process of austenitic stainless steel
K. Y. Benyounis et al.
OPTICS AND LASER TECHNOLOGY (2008)
Minimisation of the residual stress in the heat affected zone by means of numerical methods
A. G. Olabi et al.
MATERIALS & DESIGN (2007)
Joining of aluminum alloy to steel by friction stir welding
Takehiko Watanabe et al.
JOURNAL OF MATERIALS PROCESSING TECHNOLOGY (2006)
Share Paper
