Related references
Note: Only part of the references are listed.Numerical optimization of hole making in GFRP composite using abrasive water jet machining process
Hussein Mohammed Ali Ibraheem et al.
JOURNAL OF THE CHINESE INSTITUTE OF ENGINEERS (2015)
Composite Cutting with Abrasive Water Jet
A. Alberdi et al.
MANUFACTURING ENGINEERING SOCIETY INTERNATIONAL CONFERENCE, (MESIC 2013) (2013)
Study on Tool Wear and Chip Formation during Drilling Carbon Fiber Reinforced Polymer (CFRP)/Titanium Alloy (Ti6Al4V) Stacks
M. SenthilKumar et al.
INTERNATIONAL CONFERENCE ON DESIGN AND MANUFACTURING (ICONDM2013) (2013)
A review of mechanical drilling for composite laminates
DeFu Liu et al.
COMPOSITE STRUCTURES (2012)
Tool wear in drilling of composite/titanium stacks using carbide and polycrystalline diamond tools
Kyung-Hee Park et al.
WEAR (2011)
Effect of process parameter on the kerf geometry in abrasive water jet milling
A. Alberdi et al.
INTERNATIONAL JOURNAL OF ADVANCED MANUFACTURING TECHNOLOGY (2010)
Abrasive waterjet cutting of a titanium alloy: The influence of abrasive morphology and mechanical properties on workpiece grit embedment and cut quality
F. Boud et al.
JOURNAL OF MATERIALS PROCESSING TECHNOLOGY (2010)
A new model for predicting the depth of cut in abrasive waterjet contouring of alumina ceramics
J. Wang
JOURNAL OF MATERIALS PROCESSING TECHNOLOGY (2009)
An investigation on kerf characteristics in abrasive waterjet cutting of layered composites
D. K. Shanmugam et al.
JOURNAL OF MATERIALS PROCESSING TECHNOLOGY (2009)
A study of delamination on graphite/epoxy composites in abrasive waterjet machining
D. K. Shanmugam et al.
COMPOSITES PART A-APPLIED SCIENCE AND MANUFACTURING (2008)
Minimisation of kerf tapers in abrasive waterjet machining of alumina ceramics using a compensation technique
D. K. Shanmugam et al.
INTERNATIONAL JOURNAL OF MACHINE TOOLS & MANUFACTURE (2008)
Drilling of fiber reinforced plastics: A review
A. M. Abrao et al.
JOURNAL OF MATERIALS PROCESSING TECHNOLOGY (2007)
Predictive depth of jet penetration models for abrasive waterjet cutting of alumina ceramics
J. Wang
INTERNATIONAL JOURNAL OF MECHANICAL SCIENCES (2007)
Effect of traverse speed on abrasive waterjet machining of Ti-6Al-4V alloy
Ahmet Hascalik et al.
MATERIALS & DESIGN (2007)
Profile cutting on alumina ceramics by abrasive waterjet. Part 2: cutting performance models
J. Wang et al.
PROCEEDINGS OF THE INSTITUTION OF MECHANICAL ENGINEERS PART C-JOURNAL OF MECHANICAL ENGINEERING SCIENCE (2006)
Machinability of titanium alloy (Ti-6Al-4V) by abrasive waterjets
YW Seo et al.
PROCEEDINGS OF THE INSTITUTION OF MECHANICAL ENGINEERS PART B-JOURNAL OF ENGINEERING MANUFACTURE (2003)
Geometrical features and metallurgical characteristics of Nd:YAG laser drilled holes in thick IN718 and Ti-6Al-4V sheets
S Bandyopadhyay et al.
JOURNAL OF MATERIALS PROCESSING TECHNOLOGY (2002)
Share Paper
