Related references
Note: Only part of the references are listed.Tool damage and machined-surface quality using hot-pressed sintering Ti(C7N3)/WC/TaC cermet cutting inserts for high-speed turning stainless steels
Bin Zou et al.
INTERNATIONAL JOURNAL OF ADVANCED MANUFACTURING TECHNOLOGY (2015)
An experimental investigation of the influence of cutting parameters on cutting temperature in milling Ti6Al4V by applying semi-artificial thermocouple
Yujing Sun et al.
INTERNATIONAL JOURNAL OF ADVANCED MANUFACTURING TECHNOLOGY (2014)
The effects of cutting parameters on tool life and wear mechanisms of CBN tool in high-speed face milling of hardened steel
Xiaobin Cui et al.
INTERNATIONAL JOURNAL OF ADVANCED MANUFACTURING TECHNOLOGY (2013)
Modeling and predicting for surface topography considering tool wear in milling process
Chen Zhang et al.
INTERNATIONAL JOURNAL OF ADVANCED MANUFACTURING TECHNOLOGY (2013)
Effect of cutting speed on cutting forces and wear mechanisms in high-speed face milling of Inconel 718 with Sialon ceramic tools
Xianhua Tian et al.
INTERNATIONAL JOURNAL OF ADVANCED MANUFACTURING TECHNOLOGY (2013)
Empirical models and optimal cutting parameters for cutting forces and surface roughness in hard milling of AISI H13 steel
Tongchao Ding et al.
INTERNATIONAL JOURNAL OF ADVANCED MANUFACTURING TECHNOLOGY (2010)
Tool wear and tool life in end milling of 15-5 PH stainless steel under different cooling and lubrication conditions
Aldo Braghini Junior et al.
INTERNATIONAL JOURNAL OF ADVANCED MANUFACTURING TECHNOLOGY (2009)
Surface characterisation-based tool wear monitoring in peripheral milling
W. Zeng et al.
INTERNATIONAL JOURNAL OF ADVANCED MANUFACTURING TECHNOLOGY (2009)
Effect of surface integrity of hard turned AISI 52100 steel on fatigue performance
Stephen Smith et al.
MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING (2007)
Selection of an optimal parametric combination for achieving a better surface finish in dry milling using genetic algorithms
NSK Reddy et al.
INTERNATIONAL JOURNAL OF ADVANCED MANUFACTURING TECHNOLOGY (2006)
Effect of tool wear on surface finish for a case of continuous and interrupted hard turning
R Pavel et al.
JOURNAL OF MATERIALS PROCESSING TECHNOLOGY (2005)
Roughness modeling in up-face milling
K Saï et al.
INTERNATIONAL JOURNAL OF ADVANCED MANUFACTURING TECHNOLOGY (2005)
The investigation on the prediction of tool wear and the determination of optimum cutting conditions in machining 17-4PH stainless steel
WT Chien et al.
JOURNAL OF MATERIALS PROCESSING TECHNOLOGY (2003)
Effect of tool wear on roughness in hard turning
ML Penalva et al.
CIRP ANNALS-MANUFACTURING TECHNOLOGY (2002)
Share Paper
