Journal
ADVANCES IN ENGINEERING SOFTWARE
Volume 41, Issue 4, Pages 674-679Publisher
ELSEVIER SCI LTD
DOI: 10.1016/j.advengsoft.2009.10.010
Keywords
Titanium; Laser nitriding; Design of Experiment; Response surface
Categories
Funding
- Mechanical Engineering Department staff, Faculty of Engineering, Garyounis University, Benghazi, Libya (GSPLAJ)
Ask authors/readers for more resources
In this work laser surface nitriding was performed to enhance wear and erosion resistance of pure titanium by increasing its surface hardness while keeping the strength and ductility of the core for static and dynamic loading resistance. The Response Surface Methodology (RSM) in the Design of Experiment (DOE) statistical method is adopted in this research work to perform the experimental design, analysis and optimization of the laser nitriding process. Continuous wave CO2 laser was used to melt the surface, and then nitrogen gas was incorporated into the melted pool to produce hard TiN. The Response Surface Design was first created using MINTAB program, and then the laser nitriding process was performed according to the planned design. Microhardness is then measured for each sample, which represents the response, and incorporated into the design matrix. Results are then analyzed and a RSM model was developed and verified. The model is then used to perform parametric study and optimization. The maximum measured microhardness based on the original RSM design was 1382 HV0.15. However, based on the model prediction, the optimal process parameters settings were found to be as: 2.84 kW laser power, 5 mm/s scanning speed and 2076 I/h nitrogen flow rate which would result in a maximum microhardness of approximately 1920 HV0.15. (C) 2009 Elsevier Ltd. All rights reserved.
Authors
I am an author on this paper
Click your name to claim this paper and add it to your profile.
Reviews
Recommended
No Data Available