Related references
Note: Only part of the references are listed.Direct three-dimensional reconstruction of a nanoporous catalyst layer for a polymer electrolyte fuel cell
Christoph Ziegler et al.
JOURNAL OF POWER SOURCES (2011)
Progress in In Situ X-Ray Tomographic Microscopy of Liquid Water in Gas Diffusion Layers of PEFC
Jens Eller et al.
JOURNAL OF THE ELECTROCHEMICAL SOCIETY (2011)
On the Micro-, Meso- and Macroporous Structures of Polymer Electrolyte Membrane Fuel Cell Catalyst Layers
Tatyana Soboleva et al.
ACS APPLIED MATERIALS & INTERFACES (2010)
Analysis of triple phase contact in Ni-YSZ microstructures using non-destructive X-ray tomography with synchrotron radiation
P. R. Shearing et al.
ELECTROCHEMISTRY COMMUNICATIONS (2010)
New evaluation method for the effectiveness of platinum/carbon electrocatalysts under operating conditions
Myoungseok Lee et al.
ELECTROCHIMICA ACTA (2010)
3D Visualisation of PEMFC Electrode Structures Using FIB Nanotomography
S. Zils et al.
FUEL CELLS (2010)
Investigation of a Catalyst Ink Dispersion Using Both Ultra-Small-Angle X-ray Scattering and Cryogenic TEM
Fan Xu et al.
LANGMUIR (2010)
Ptychographic X-ray computed tomography at the nanoscale
Martin Dierolf et al.
NATURE (2010)
Effectiveness factor of Pt utilization in cathode catalyst layer of polymer electrolyte fuel cells
Zetao Xia et al.
CANADIAN JOURNAL OF CHEMISTRY-REVUE CANADIENNE DE CHIMIE (2008)
Electron microscopy techniques for the analysis of the polymer electrolyte distribution in proton exchange membrane fuel cells
Frieder Scheiba et al.
JOURNAL OF POWER SOURCES (2008)
Determination of the effective diffusion coefficient in porous media including Knudsen effects
Deqiang Mu et al.
MICROFLUIDICS AND NANOFLUIDICS (2008)
Instability of supported platinum nanoparticles in low-temperature fuel cells
Y. Shao-Horn et al.
TOPICS IN CATALYSIS (2007)
X-ray computed tomography in Zernike phase contrast mode at 8 keV with 50-nm resolution using Cu rotating anode X-ray source
Andrei Tkachuk et al.
ZEITSCHRIFT FUR KRISTALLOGRAPHIE (2007)
Electron tomography of nafion ionomer coated on Pt/carbon black in high utilization electrode for PEFCs
Hiroyuki Uchida et al.
JOURNAL OF PHYSICAL CHEMISTRY B (2006)
An improved two-dimensional agglomerate cathode model to study the influence of catalyst layer structural parameters
W Sun et al.
ELECTROCHIMICA ACTA (2005)
Microstructural changes of membrane electrode assemblies during PEFC durability testing at high humidity conditions
J Xie et al.
JOURNAL OF THE ELECTROCHEMICAL SOCIETY (2005)
Porosimetry of MEAs made by Thin film decal method and its effect on performance of PEFCs
J Xie et al.
JOURNAL OF THE ELECTROCHEMICAL SOCIETY (2004)
Ionomer segregation in composite MEAs and its effect on polymer electrolyte fuel cell performance
J Xie et al.
JOURNAL OF THE ELECTROCHEMICAL SOCIETY (2004)
Modeling two-phase behavior in PEFCs
AZ Weber et al.
JOURNAL OF THE ELECTROCHEMICAL SOCIETY (2004)
PEM fuel cell electrodes
S Litster et al.
JOURNAL OF POWER SOURCES (2004)
Single domain PEMFC model based on agglomerate catalyst geometry
NP Siegel et al.
JOURNAL OF POWER SOURCES (2003)
Share Paper
